678359
8
Verklein
Vergroot
Pagina terug
1/18
Pagina verder
Tyre repair kit* 7
Inflation hose with plug
Compressor
Tyre inflation hose
Tyre inflation pressure indicator
Air release valve
ON and OFF switch
12 volt cable connector
Tyre inflator bottle with sealing agent
Replacement valve core
The valve remover has a slot at its lower end which fits into the valve core. This is
the only way in which you can remove and re-install the valve core from the tyre valve.
The same also applies to the replacement valve core .
Preparing to use the tyre repair kit
Before using the tyre repair kit, carry out the following preparatory work:
Park the vehicle as far away as possible from the traffic flow. Park on as flat and firm
a surface as possible.
–Have all the occupants get out. While changing a wheel, the occupants of the
vehicle should not stand on the road (instead of behind a crash barrier).
Switch off the engine and engage 1st gear or if your vehicle is fitted with an auto-
matic gearbox, position the selector lever into position P.
Apply the handbrake firmly.
Check whether you can carry out the repairs with the tyre repair kit page 6,
“General information”.
If a trailer is coupled, uncouple it.
Remove the tyre repair kit from the luggage compartment.
Stick the sticker page 6, fig. 5 on the dash panel in view of the driver.
Do not remove the foreign body, e.g. screw or nail, from the tyre.
Unscrew the valve cap.
Use the valve remover to remove the valve core and place it down on a clean
surface.
Seal and inflate tyres
Sealing tyres
Forcefully shake the tyre inflator bottle page 6, fig. 5 several times.
Firmly screw inflation hose onto the tyre inflator bottle in a clockwise direction
. The film on the cap is pierced automatically.
Remove the plug from the inflation hose and plug the open end fully into the
tyre valve.
Hold the bottle with the floor facing upwards and fill the whole sealing agent in
the tyre inflator bottle into the tyres.
Remove the empty tyre inflator bottle from the valve.
Screw the valve core back into the tyre valve using the valve remover .
Pumping up the tyres
Screw the tyre inflation hose page 6, fig. 5 of the air compressor firmly onto
the tyre valve.
Check whether the air release valve is closed.
Start the engine and run it in idle.
Plug the cable connector into the 12 Volt socket in the vehicle, see Owner's
manual.
Switch on the air compressor with the ON and OFF switch .
Allow the air compressor to run until reaching a pressure of 2.0 - 2.5 bar. Maximum
run time of 8 minutes !
Switch off the air compressor with the ON and OFF switch.
If you cannot reach an air pressure of 2.0 – 2.5 bar, unscrew the tyre inflation hose
from the tyre valve.
A
3
A
4
A
5
A
6
A
7
A
8
A
9
A
10
A
11
A
1
A
11
A
2
A
1
A
10
A
3
A
10
A
3
A
10
A
1
A
5
A
7
A
9
A
8
A
5
s3lg.1.book Page 7 Monday, September 20, 2010 8:07 AM
8

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Skoda Superb - 2010 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Skoda Superb - 2010 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,8 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Skoda Superb - 2010

Skoda Superb - 2010 Aanvulling / aanpassing - Nederlands - 18 pagina's

Skoda Superb - 2010 Gebruiksaanwijzing - Nederlands - 295 pagina's

Skoda Superb - 2010 Aanvulling / aanpassing - Deutsch - 18 pagina's

Skoda Superb - 2010 Gebruiksaanwijzing - Deutsch - 295 pagina's

Skoda Superb - 2010 Gebruiksaanwijzing - English - 287 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info