Instruction Manual
25
E04054
4.2.4 Attaching / Removing the Transducer
The masthead transducer is attached to the masthead bracket
using a simple quick-release clamp system.
1 - Slide the locating pegs on the rear of the transducer base
into the slots on the masthead bracket.
2 - Rotate the transducer down onto the masthead bracket.
3 - The transducer base will then lock into place (Fig 4.12) -
WARNING Ensure the quick release clip is properly engaged by pulling it
fully forward.
Fit the transducer cable to the socket in the back of the mast-
head transducer.
NOTE To avoid damage, it is recommended that the masthead trans-
ducer be taken down at the end of the season if the boat is to
be laid up or lifted out.
Simply remove the transducer cable, pull the release clip back
and lift the transducer off the masthead bracket (Fig 4.13) -
Fig 4.12 - Attaching Masthead Transducer
Fig 4.13 - Removing Masthead Transducer
Pull back
Lift
Lock
WARNING To avoid corrosion of the electrical contacts, always fit the cover
supplied over the end of the masthead cable.
Locating
Peg
123
12