23322
98
Verklein
Vergroot
Pagina terug
1/108
Pagina verder
901-10037001/1.1 FS 20/25 Operators Manual
Page 5.26 Maintenance and Troubleshootin
g
Kongsberg Simrad Mesotech Ltd.
Port Coquitlam, BC - Canada
If the impedance between the cable’s two conductors is too low, then
possible problems are bad splices, water in cable, moisture in slip rings (if
connected during test), or damaged cable. If the impedance between the
cable’s conductors and the vessel’s hull is too low, then possible causes are
damaged outer jacket on cable, bad splice, or bad slip rings (if connected
during test).
Closed Loop Resistance
As previously mentioned, the closed loop resistance must be less than 100 ohms for
proper operation of the FS system. This test should be done with the FS system
disconnected, but with the winch slip rings included.
To do the test, the conductors at one end of cable should be jumpered together
(shorted). An ohmmeter is then used at the other end of cable to measure the
resistance between the conductors.
Voltage and Current at Trawl Unit
Further checks of cable losses can be performed by measuring both the voltage and
current at the trawl unit. This measurement requires the trawl unit electronics to be
connected and the FS system powered up. This test is done where the trawl cable
pigtail plugs into the sonar head. Jumpers will be required to breakout the signals
for connection to a handheld multi-meter.
Caution!
There are DC voltages on the trawl cable that are capable of
delivering a lethal electric shock!
The minimum voltage at the trawl unit is 55 Vdc and the current should be
approximately 250 mA with sonar head only connected and 325 mA with both sonar
head and sensor module (current readings will vary depending on operation mode -
i.e., scan speed and range, etc.). This test is recommended more for a service
representative than ship's personnel in the field.
Test for Water In Cable
When a trawl cable is damaged or there is a poor splice, salt water can get into the
cable. As a result, the cable may act as a battery, producing a small dc voltage
across the conductors of the cable. This is detrimental to the operation of the FS
system and all affected cable should be removed.
To test for this, the trawl cable should be disconnected from the FS system and a
voltage meter connected to the trawl unit end of the cable. If water is present, then
98

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Simrad FS25 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Simrad FS25 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,8 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info