752909
26
Verklein
Vergroot
Pagina terug
1/85
Pagina verder
26 GB/IE
Inserting / replacing batteries
Open the battery compartment cover on the
remote control.
Insert two batteries into the battery compartment
or replace the old batteries with new ones. Only
use batteries of the specified type (see „Technical
data“).
Note: When inserting the batteries, be sure to
observe the correct polarity. This is shown in
the battery compartment.
Close the battery compartment cover on the
remote control.
Operation
Due to the complexity of domestic environments the
product may skip some areas when cleaning. For
better cleaning results we recommend using the
product daily.
Preparation
Remove any obstacles prior to use, for example
power cables, toys and other objects.
Tuck rug edges under the rug. Do not allow
curtains and tablecloths to touch the floor.
Try to position furniture properly.
Test the product in areas with stairs. This allows
you to check whether the product can detect
the edge of area which it could fall off.
Do not stand in the way of the product when it
is working. Otherwise the product will be una-
ble to clean these areas.
Cleaning
Press the Clean button on the robot vacuum
cleaner 11 or on the remote control 27 if the
display shows „88:88“. The notification will
switch to AUTO and the product will begin the
cleaning programme. If the product is in Standby
mode, the initial „88:88“ notification will ap-
pear after the Clean button is pressed for the
first time. When the Clean button is pressed for
a second time, the notification switches to
AUTO and the cleaning programme begins.
Note: During automatic cleaning, the product
will switch to Corner mode when necessary, if
it is nearing a corner. After cleaning the corner,
the product will switch back to Normal mode.
To pause the cleaning programme part way
through, press the Clean button on the robot
vacuum cleaner 11 or on the remote control 27 .
To continue the cleaning programme, press the
Clean button on the robot vacuum cleaner 11 or
on the remote control 27 again within 15 sec-
onds. If the pause lasts longer than 15 seconds,
the product will switch to Sleep mode and the
notification in the display 1 will go off.
You can also switch the product to Sleep mode
manually. To do so, hold the Clean button on
the robot vacuum cleaner 11 down for a few
seconds until the notification in the display 1
goes off.
With the product paused, you can use the
directional buttons 26 on the remote control to
manually move it left / right / forwards / back-
wards.
Cleaning modes
For better cleaning results, the product has various
cleaning Modi. You can select the modes by pressing
the buttons on the product or on the remote control.
Spot mode
This mode is suitable for very dirty or very dusty
areas. In Spot mode, the product will focus on one
area to clean.
During cleaning, press the Spot mode button
on the robot vacuum cleaner 14 or the remote
control 29 to start this mode.
As soon as the surface is sufficiently clean, the
product continues with the automatic cleaning
programme.
Note: You can also end Spot mode by pressing
the Clean button once on the robot vacuum
cleaner 11 or on the remote control 27 .
26

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Silvercrest IAN 306041 SSR 3000 A1 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Silvercrest IAN 306041 SSR 3000 A1 in de taal/talen: Nederlands, Duits, Engels, Frans, Pools, Zweeds als bijlage per email.

De handleiding is 3,6 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info