en Service programmes
28
■ For cleaning and descaling, only use
the tablets intended for such
purpose.They have been specially
developed for this appliance, and
new stocks can be ordered through
customer service. ~ "Accessories"
on page 11
■ Never insert descaling tablets or
other products into the grounds
compartment.
■ Never interrupt the service
programme.
■ Prior to starting a service
programme, remove, clean and
re-insert the brewing unit. Rinse the
milk system.
■ At the end of a service programme,
wipe down the appliance using a
soft, damp cloth to immediately
remove any descaler residue. This
residue may cause corrosion.
■ New sponge cloths may contain
salts. Salts can cause rust film on
stainless steel, so cloths must
always be washed out thoroughly
before use.
■ Using a water filter increases the
intervals until a service programme
needs to be performed.
■ If one of the service programmes is
interrupted, e.g. by a power failure,
proceed as follows:
The appliance automatically starts a
special rinsing process.
1. Rinse out the water tank.
2. Pour in fresh, still water up to the
"max" marking and confirm.
The programme starts and rinses the
appliance.Duration: approx.
2 minutes.
3. Empty, clean and re-insert the drip
tray.
4. Empty, clean and re-insert the milk
container.
The programme has finished. The
appliance is ready for use again.
5. Press $/± button to close the
programme.
Rinse milk system
The milk system is automatically
cleaned with a short jet of steam directly
after preparing a milk drink.
For particularly thorough cleaning, the
milk system can be additionally rinsed
with water.
Duration: approx. 2 minutes
1. Press the $/± button to open the
menu.
2. Use the rotary selector to select
"Rinse milk system".
3. Press the rotary selector to start the
programme.
4. Empty, clean and re-connect the milk
container.
5. Place an empty glass under the
outlet system and confirm.
The programme runs.
6. Empty, clean and re-connect the milk
container.
7. Empty the glass.
The programme has finished. The
appliance is ready for use again.
8. Press the $/± button to exit the
programme.
The milk system should also be subject
to thorough manual cleaning at regular
intervals. ~ "Cleaning the milk system"
on page 26
