Overview of programmes en
21
Programme selection
You can select a suitable programme
according to the type of utensils and
degree of soiling.
Information for test institutes
Test institutes receive the information for
comparability tests (e.g. according to
EN60436).
These are the conditions for conducting
the tests, however these are not the
results or consumption values.
Request by e-mail to:
dishwasher@test-appliances.com
The product number (E no.) and the
production number (FD) are required
which you can find on the rating plate
9: on the appliance door.
TurboSpeed 20 min.
TurboSpeed 20 min. -
especially quick rinsing
programme with one-off
preheating*
* depending on model
The appliance is heated up once
(approx. 25 min.), then the appliance is
loaded and several quick rinse cycles
(20 min. each) can run in succession.
Note
Detergent tablets are not suitable for
this programme, as the detergent
cannot completely dissolve within
the short time. Therefore always use
powder detergents and ensure that
the salt and rinse aid dispensers are
always filled and set to the correct value
(see chapters entitled “Water softening
system” and “Rinse aid”).
Please read the operation carefully,
the programme differs from the other
programmes.
1. Open the door.
2. Switch on ON/OFF switch (.
3. Select programme TurboSpeed 20
min.
• flashes on the digital display h
(• = Heating phase).
4. Press START button `.
5. Close the door.
The heating up phase of the empty
appliance starts. The light spot
on the floor is lit constantly. If
the appliance is loaded before
the heating phase, the duration
of the heating phase is extended.
6. As soon as the light spot on the floor
flashes, open the appliance.
p flashes on the digital display h
(p = Load).
Warning! Interior is hot.
7. Load the appliance and start
the rinsing phase by pressing
the START button `.
8. When the rinse cycle has ended,
the light spot on the floor flashes
again and the buzzer is activated.
9. Open the door.
‹:‹‹ is indicated on the digital
display h, remove the utensils.
Shortly afterwards p flashes again
on the digital display h.
Warning! The utensils are hot and
sensitive to shock!
10.If more rinse cycles are required,
reload dishwasher, press the START
button ` and close the door.
11.If no more rinse cycles are required,
switch off ON/OFF switch ( and
close the door.
