en Installation and connection
38
Use only a residual current operated
circuit-breaker which features
the symbol ‚. Only this extension
guarantees compliance with
the currently valid regulations.
The appliance features a water
damage protection system. Please
note the system will not function
unless the power supply
is connected.
Removing the appliance
Also observe
the sequence of worksteps here.
1. Disconnect the appliance from
the power supply.
2. Turn off the water supply.
3. Disconnect the waste water
and fresh water connections.
4. Loosen fastening screws for the
furniture parts.
5. If fitted, remove the base panel.
6. Pull out the appliance, carefully
pulling the hose behind.
Transportation
Empty the dishwasher and secure loose
parts.
Drain the appliance according to the
following steps:
1. Turn on the tap.
2. Open the door.
3. Switch on ON/OFF switch (.
4. Select programme with the highest
temperature.
The expected programme duration is
indicated on the numerical display
h.
5. Press START button `.
6. Close the door.
Programme sequence starts.
7. Open door after approx. 4 minutes.
8. Press START button ` until ‹:‹‚
is indicated on the digital display.
9. Close the door.
10.Open door after approx. 1 minute.
The numerical display indicates
‹:‹‹.
11.Switch off ON/OFF switch (.
12.Turn off the tap, disconnect supply
hose and drain water.
Transport appliance upright only.
(This prevents residual water from
running into the machine control and
damaging the programme sequence.)
Protection against frost
Protection again st frost (Emptying the applia n ce)
If the appliance is in a room where there
is a risk of frost (e.g. holiday home),
empty the appliance completely (see
Transportation).
