527327
20
Verklein
Vergroot
Pagina terug
1/32
Pagina verder
20
Replacing the cooking compartment bulb
Heat-resistant 230 V/25 W halogen bulbs with seals are
available from the after-sales service. Please specify the E
number and FD number of your appliance.
: Risk of burns!
Allow the cooking compartment and cooking compartment light
to cool before changing the bulb.
Always use a dry cloth to remove a new halogen bulb from the
packaging, otherwise it will not last as long.
1.Switch off the fuse in the fuse box or unplug at the mains.
2.Turn the cover anti-clockwise to remove.
3.Remove the bulb and replace with a bulb of the same type.
4.Slide the new seals and the clamping ring onto the glass
cover in the right order.
5.Screw the glass cover with the seals back on again.
6.Connect the appliance to the mains and reset the clock.
Never operate the appliance without the glass cover and seals.
Replacing the glass cover or seals
Any damaged glass cover or seals must be replaced. Please
provide the after-sales service with the E number and FD
number of your appliance.
Turning the temperature selector cancels
the cooking operation
A temperature outside of the possible tem-
perature range has been set
Check the temperature ranges for the
operating modes. Press the
button
0 and :‹‹ light up in the display
Power cut Reset the clock time (see section: "Time-
setting options")
”‰ is shown in the display
The automatic safety switch-off is active Press any button.
The
¯ indicator appears even though the
water tank is full
The water tank has not been pushed in
properly
Slide in the water tank until it engages
The detection system is not working Call the after-sales service
The
¯ indicator appears even though the
water tank is not yet empty, or the water
tank is empty but the
¯ indicator does not
appear
The water tank is dirty. The mobile water
level indicators are jammed
Shake and clean the water tank. If the
parts cannot be released, obtain a new
water tank from the after-sales service.
The water tank empties for no discernible
reason. The evaporator dish is overflowing
The water tank was not closed properly Close the lid until you feel it engage.
The tank cover seal is dirty Clean the seal
The seal in the tank cover is defective Obtain a new water tank from the after-
sales service
The evaporator dish has boiled dry even
though the water tank is full
The water tank has not been pushed in
properly
Slide in the water tank until it engages
The feed line is blocked Descale the appliance. Check whether the
water hardness is set correctly
The
¯ indicator appears
The appliance has not been used for at
least 2 days and the water tank is full
Empty and clean the water tank. Always
empty the water tank after cooking
There is a "pop" noise during cooking Cold/warm effect with frozen food, caused
by the steam
This is normal.
When you cook with steam, a lot of steam
is created
The appliance is being automatically cali-
brated
This is normal.
When cooking with steam, a lot of steam is
created again
The appliance is unable to calibrate itself
automatically if cooking times are too
short
Reset the appliance to the factory settings
(see Basic settings section). Then start
steaming at 100 °C for 20 minutes
Steam escapes from the ventilation slots
during cooking
This is normal.
The appliance is not producing steam
properly
Limescale has formed in the appliance Start descaling (see Section: Descaling)
Error message
“‹‚‚ appears in the dis-
play
A button was pressed for too long or is
jammed
Press the
0 button to clear the fault mes-
sage. Press each button and check that it
is clean
An
... error message appears in the dis-
play
Technical fault.
Press the
0 button to delete the error
message. Reset the clock if required. If the
error message appears again, call the
after-sales service
The appliance is not heating. The colon
flashes in the display
A button combination was actuated Set the Steam operating mode to 35 °C,
then press and hold the
@ button until a
signal sounds. Press the
@ button again
briefly
Problem Possible cause Notes/remedy
20

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Siemens-HB34D553

Zoeken resetten

  • Ik heb een vraag over het ontkalken van mijn stoombakoven HD34D553.
    In de beschrijving staat dat ik 300 ml met 60 ml moet mengen voor de ontkalkoplossing. De watertank is dan echter niet vol en het signaal blijft dan ook afgaan als ik wil starten.
    En ik vraag me verder af of de functie op ‘calc’ moet staan of op ‘reinigen’. Gesteld op 24-10-2019 om 14:07

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Siemens HB34D553 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Siemens HB34D553 in de taal/talen: Engels als bijlage per email.

De handleiding is 2,96 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Siemens HB34D553

Siemens HB34D553 Gebruiksaanwijzing - Nederlands - 32 pagina's

Siemens HB34D553 Gebruiksaanwijzing - Deutsch - 32 pagina's

Siemens HB34D553 Gebruiksaanwijzing - Français - 36 pagina's

Siemens HB34D553 Gebruiksaanwijzing - Italiano - 36 pagina's

Siemens HB34D553 Gebruiksaanwijzing - Português - 36 pagina's

Siemens HB34D553 Gebruiksaanwijzing - Espanõl - 36 pagina's

Siemens HB34D553 Gebruiksaanwijzing - Polski - 36 pagina's

Siemens HB34D553 Gebruiksaanwijzing - Dansk - 32 pagina's

Siemens HB34D553 Gebruiksaanwijzing - Svenska - 32 pagina's

Siemens HB34D553 Gebruiksaanwijzing - Norsk - 32 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info