22
Disposal
This device complies with the European Guideline 2002/96/EG for waste electrical and electronic equipment (WEEE). This pro-
vides the framework for an EU-wide recall and conversion of waste electronic devices. Please consult a specialist dealer for
information about current disposal methods.
Subject to change.
LED display anode and service
In normal operations, the LED “anode” is constantly lit, the LED “service” is off.
If one of the two LEDs flashes, this indicates an “error condition”.
To begin with, please reset the device ➜ RESET. To do this, proceed as follows:
Firstly turn the dial to the setting ”
• ”.
After that, press the “fast-heating” button .
If the cause of the error condition does not exist directly after the reset, the device will again return to its normal mode of func-
tion. Otherwise the device will again indicate an “error condition”.
In this case please contact the customer service operator.
Cleaning
• Wipe with a damp cloth. Do not use any sharp or coarse cleaning products.
• Do not use a steam cleaner.
Customer Service
In order to avoid hazards, repairs may only be carried out by a customer service operator licensed by us.
The initial service through our customer service operator should take place around two years after the first operation. At this
time, the device will potentially be decalcified. Afterwards, the customer service operator will recommended a date for the next
service. Specify the E-No. and FD-No. when phoning the customer service operator!
When requesting customer service, please enter the E-No. and the FD-No. of your device.
You will find the numbers on identification plate between the water access pipes of the reservoir.
E-Nr. FD
Siemens-Electrogeräte GmbH
