ENGLISH
11
“T-DIR” is displayed and the sound that bypasses
the tone circuitry will be heard.
To cancel the tone direct function, press this button
again to display “D-OFF”.
To listen to a program source without the tone effect.
10
Each time this button is pressed, the corresponding
tone mode is selected and shown for 5 seconds as
follows:
BAS(s) TRE(ble)
Note:
When the tone direct function is activated, the tone
mode cannot be entered and “T-DIR” is displayed.
Enter the tone mode.
8
If the tone display disappears, start from the step 8
again.
Notes:
Extreme settings at high volume may damage your
speakers.
In general, the bass and treble levels are adjusted
to 0.
At the desired tone mode, adjust the tone as
desired.
9
Adjusting the tone(bass and treble)
“BAL” is displayed for 5 seconds.
Enter the balance mode.
11
If the balance display disappears, start from the
step 11 again.
When the BALANCE + / - buttons on the remote
control are pressed, it enters the balance mode
automatically without pressing the BALANCE
button on the front panel.
Note:
In general, the balance level is set to the center
position(red dot).
Adjust the sound volume balance between
the left and right speakers.
12
Adjusting the sound volume balance
