Handleiding Shark S3200 (pagina 7 van 8) (Engels)

668649

Verklein

Vergroot

Pagina terug

1/8

Pagina verder

OPERATING INSTRUCTIONS

Components

Indicator Lights: The steam cleaner has

an indicator light located at the base of the

unit that will illuminate when the unit is

plugged into the 120V wall outlet.

Red Light: When the red indicator light

illuminates, this indicates that the power is

“On”.

Green Light: When the green indicator

light illuminates, the steam is ready.

CAUTION: Read the instructions for

“Filling or Refilling Your Steam Cleaner

with Water” before opening the safety filler

cap.

CAUTION: Always unplug before filling.

ALLOW UNIT TO COOL FOR FIFTEEN

(15) MINUTES BEFORE REFILLING.

IMPORTANT: Do NOT add cleaning

solutions, scented perfumes, oils or any

other chemicals to the boiler in this

appliance. Use tap water or

distilled/purified water if the tap water

in your area is very hard.

Attaching the Shoulder Strap

Using the detachable shoulder strap

allows for greater freedom of

movement when both hands are

needed for various cleaning tasks. To

attach the shoulder strap to the steam

cleaner, simply snap the shoulder strap

hooks onto the connecting rings on the

unit body. (Fig. 12)

Using Your Steam Cleaner

After you have assembled the steam

cleaner and are ready to use:

1. When you press the steam trigger it

will lock in place and you will have

continuous steam.

2. To stop the flow of steam, press the

steam trigger release button.

3. When using the unit with the

shoulder strap, avoid rocking or

tilting the unit excessively as this

may cause water to enter the hoes

and be discharged along with the

steam.

Fig. 2

WARNING: Extreme care should be

taken when refilling the unit. Allow unit

to cool for15 minutes before refilling.

When refilling the steam cleaner while the

boiler is still hot, there is a risk that

water will squirt back during filling and

cause scalding. Use caution when

opening the filler cap as the cap may

become hot during use and escaping

steam can cause scalding.

5. To attach the concentrator nozzle or

the steam/garment diffuser to the

nozzle: align the two pins on the end

of the concentrator nozzle or

steam/garment diffuser with the

notches in the nozzle of the unit.

(Fig. 2)

6. Push the attachment into the nozzle

unit it stops against the unit. Turn

clockwise ¼ turn to lock the

attachment into place. Allow

approximately 5 minutes for vapor

to reach its working temperature and

pressure. When the unit is ready for

use, the green indicator light will

illuminate. Always point the nozzle in

a safe direction. At the start, some

water will come out from the nozzle.

This is normal.

NOTE: When the steam cleaner has run

out of water, steam output will cease.

CAUTION: This appliance is under

pressure. After every use, press steam

trigger button until all pressure has been

released before removing safety cap. Allow

unit to cool for fifteen (15) minutes before

refilling.

Unit

Nozzle

Steam/Garment

Diffuser

Fig. 1

Connecting

points

Connecting

points

Filling or Refilling Your Steam

Cleaner With Water

Fig. 12

IMPORTANT: Always insure that the unit

is “UNPLUGGED” from the wall receptacle

prior to initial filling or re-filling the water

tank and has been allowed to cool. Never

attempt to fill this unit under a water tap,

always use the measuring cup and

funnel provided.

IMPORTANT: When using the

steam cleaner with the shoulder

strap, avoid rocking or tilting the unit

excessively as this may cause water

to enter the hose and be discharged

along with the steam.

1. Before filling or refilling the steam

cleaner, make sure that the unit is NOT

plugged in and has been allowed to cool

for fifteen (15) minutes.

2. Press the locking steam trigger on the

handle of the unit to vent any residual

steam that is in the boiler.

3. Place the unit on a flat, stable surface.

Slowly, press and turn the filler cap

counter clockwise until it is removed.

4. Place the funnel in the tank opening.

(Fig. 1) Fill with a maximum of one filling

flask or 9.5 oz (280 ml) of water. Do Not

Overfill. Turn the safety cap clockwise

to replace.

NOTE: To remove or replace the filler cap,

push down and rotate it clockwise to tighten

or counter clock-wise to loosen.

NOTE: Filling the unit with hot water will

shorten the heat up time.

8 5

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Shark S3200 Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info