section General Care and Cleaning.
Switch settings
The following settings can be selected:
P The appliance remains switched on as
long as the rotary switch is held in this
position.
0 The appliance is switched off.
1 Low power
2 High power
Safety switch
A special safety switch in the motor housing
ensures that the appliance can only be
operated once the blender jug is properly
fitted.
Before removing the blender jug, make sure
that the control switch is in position 0. This
also applies when fitting the blender jug to
the motor housing. If the switch is not in its
off-position (0), the motor will start
immediately.
Operation
-
Fit the blender jug to the motor housing
with its handle on the right. Ensure that
the contact pin is properly engaged in the
safety switch mechanism.
-
Put the liquid ingredients into the
blender jug. The jug has a maximum
capacity of 1500 ml. To avoid possible
foaming or spilling when processing
foamable or thin liquids such as milk, do
not fill the jug over the 1000 ml mark.
-
Put the lid on. To add ingredients during
operation, the stopper in the centre of the
lid can be removed by turning it in an
anti-clockwise direction and then lifting it
off. Do not put any objects into the
blender jug while the appliance is
operating.
-
Insert the plug into the wall outlet and
use the control switch to select the
required power setting. Depending on
the food to be processed, the appliance
may also be operated for short periods of
time with the pulse setting “P”. The main
indicator light shows that the appliance is
switched on. Do not operate when the
blender jug is empty.
-
After using the blender, switch off and
remove the plug from the wall socket.
Wait until the motor has come to a
complete standstill before removing the
blender jug.
General Care and Cleaning
● Always remove the plug from the wall
socket before cleaning the appliance.
● To avoid the risk of electric shock, do not
clean the motor housing or the power
cord with water and do not immerse
them in water. The motor housing may
be wiped with a slightly damp, lint-free
cloth.
● Do not use abrasives, harsh cleaning
solutions or hard brushes for cleaning,
and do not clean in a dish-washer.
-
For cleaning after use, fill the blender jug
with approximately 1250 ml warm water
and a mild cleaning detergent. Let the
appliance run for a short period as
described in the section Operation. Then
rinse the blender jug, lid and stopper with
fresh water. All parts must me
thoroughly dried afterwards.
-
The blender jug base lock with the blade
insert can be removed for thorough
cleaning. To remove, turn the base lock
in anti-clockwise direction until it can be
taken off. Caution: the blades are
extremely sharp. The blade unit may be
cleaned with a suitable brush. When re-
fitting the blade insert with its seal,
ensure that it is inserted in the threaded
part of the base lock. Fit the base lock
with seal and blade insert to the blender
jug from below and turn the base lock
clockwise until it is securely fitted.
Caution: to prevent injuries, take care
not to touch the contact pin. If the safety
switch on the housing cannot be
activated by the safety pin, it may be an
indication that the base lock has not been
fitted properly. If necessary, tighten the
5
