Handleiding Severin KA 9582 (pagina 13 van 84) (Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Pools, Deens, Zweeds, Fins)

761728

Verklein

Vergroot

Pagina terug

1/84

Pagina verder

142 x 208 mm

Pre-heating cups

For optimum taste enjoyment we recommend to pre-heat

the cups. Rinse the cups with hot water or place them on

the cup-warming top.

Making espresso

∙ Remove the water container, open the lid and ll with

fresh water, observing the min/max marking.

∙ Ensure that the rotary control is set to .

Using espresso powder:

∙ Fit the lter insert for one or two cups into the lter

holder.

∙ Load the lter insert with the desired amount of espresso

coffee. We recommend 7.5 g per cup.

∙ Use the tamper to push down the espresso coffee

evenly and rmly with a pressure of around 15 kg.

∙Hint: After tampering, the compressed surface should

be about 2 mm down from the rim inside the lter

holder.

∙ Remove any excess coffee from the rim of the lter

holder.

Using ESE pods:

∙ Fit the lter insert for ESE pods into the lter holder.

∙ Insert a pod.

∙ Fit the lter holder with the handle facing left to

the boiler outlet. Secure the lter holder by turning the

handle to the right, locking it underneath the symbol.

∙ Place one or two cup(s) onto the drip tray underneath

the outlet opening.

∙ Press to turn the unit on. The cup symbols start

ashing slowly while the unit is pre-heating.

∙ Once the cup symbols are permanently lit, the brewing

process can be started by pressing or button.

∙ Once brewing is complete, remove the cup(s) and

switch the unit off.

∙ Allow the lter holder to cool down, then remove and

clean it as described in Cleaning and care.

∙ To avoid spilling, always empty the drip tray in good

time, observing the red oat indicator.

∙Hint: If the appliance has been used for frothing or

hot water, it must be allowed to cool down before

making espresso. The and buttons are

ashing rapidly to show that the unit is too hot.

To accelerate cooling, you can release water from

the panarello. Place a suitable container underneath

the panarello and set the rotary control to for

around 2 seconds. The unit is ready for use when the

and buttons are permanently lit.

Making cappuccino

∙ First prepare the espresso as described in Making

espresso.

∙ Fill a suitable heat-resistant jug with about 100 ml of

fresh, cold milk from the fridge.

∙ To prevent the milk from spilling over during the frothing

process, the jug should be only half full.

∙ Press . The button ashes while the unit is pre-

heating.

∙ Once the button shows a steady light, place the milk

jug underneath the panarello so that the lower of the

panarello is just submerged in the milk.

∙ Turn the rotary control to the position. The

panarello is now open.

∙ Turn the jug with a circular motion for around 40-45

seconds.

∙ Once the milk is sufciently frothy, turn the control back

to the espresso symbol ( ).

∙ Use a spoon to spread the milk froth over the espresso.

The proper ratio should be 1/3 espresso, 1/3 hot milk

and 1/3 milk froth.

Dispensing hot water

∙ Remove the water container, open the lid and ll with

fresh water, observing the min/max marking.

∙ Press to turn the unit on.

∙ Once the and buttons shows a steady light,

place a suitable container underneath the panarello.

∙ Set the rotary control to .

∙ Once hot water has been drawn, set the rotary control

back to .

Change factory settings

∙ The unit has various functions which may be modied as

follows:

∙ Turn the unit on and wait until the cup symbols are

permanently lit.

∙ Press the button for 10 seconds to enter the Change

factory settings mode. All three buttons ash alternately.

∙ Modify the default factory settings as described further

below.

∙ If no input is registered for about 15 seconds, the unit

returns to ‘Ready’ mode.

∙ To return the various functions (water hardness,

automatic switch-off, temperature, amount) back

to their factory settings, press the buttons and

simultaneously, keeping them pressed for three

seconds. The , and buttons start ashing

and two beep signals are heard. The appliance switches

off.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Severin KA 9582 Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info