29
EN
Adjusting milk froth quantity
When the frothing process is started, please press and hold the Start/
Stop button (H.3)
until the desired quantity of milk froth is reached.
The display element (H.1) is lit during this process. When you release
the Start/Stop button (H.3) the respective milk froth quantity will be
memorised.
Note: After having released the Start/Stop button (H.3) there will still
be coming out a little quantity of milk froth.
Note: If you change the milk froth quantity, the setting for the milk
quantity with hot milk will change too, since the same strainer support is
used.
3.3 Hot milk
Advice: Use – as you like – milk with a fat content of up to 3.5%.
Important: Please clean the strainer support for the milk (D) carefully
after every use in order to avoid the formation of milk bacteria and to
ensure the function of the strainer support.
1. Assemble the strainer support for milk (D).
– Put the milk pipe (D.1) into the strainer support (D).
– Put the valve (D.2) with the tube into the milk pipe (D.1).
2.
Note: To heat up the milk, the valve (D.2) must be closed, see gure.
The nose at the milk pipe (D.1) must be oset by 180° with the nose at
the valve (D.2).
3. Now, open brewing unit (A). For this purpose, fully fold open the bracket
closure (B) and insert the strainer support (D).
4. Close the brewing unit (A) by rmly pressing the bracket closure (B)
downwards.
5. Put a high glass, a coee mug or another suiable container onto the
drainage grille (G) and plunge the tube (D.3) into the milk container.
6. Now press shortly the Start/Stop button (H.3)
. The preparation
process is started (display element (H.1) is ashing). After a short
heat-up phase the cup is lled with hot milk.
