10
Thermal safety cut-out
This appliance is equipped with a thermal
safety cut-out, which switches it off
automatically in case of overheating. Should
this occur, let the appliance cool down to
room temperature before using it again.
Cable storage compartment
There is a cable storage the rear of the
appliance. Open the compartment and
unwind the power cord to the required length
before use.
Short-time operation
The appliance has been designed for
short-term operation only, i.e. it should not
be operated continuously for more than 1
minute. Allow it afterwards to cool down
suffi ciently before switching on again.
Before using for the fi rst time
Before the appliance is used for the fi rst
time, it must be cleaned as described in the
section General Care and Cleaning.
Switch
The appliance is equipped with a 3-position
switch.
0 appliance switched off
1 slow juice extraction
2 fast juice extraction
We recommend starting extraction with
the slow setting and switching to the faster
setting only when necessary.
Operation
∙ Fit both juice and pulp containers.
∙ Place the fi lter holder onto the drive unit,
ensuring that the small opening of the
juice outlet is positioned directly above
the juice container.
∙ Fit the fi lter into its holder, pushing it
fi rmly down. It is important that the fi lter is
securely attached and not at an angle.
∙ Place the transparent lid onto the fi lter
holder. Use the two locking clamps to lock
the lid to the base, which will activate the
safety switch.
∙ Fit the fi lling guard onto the feeder chute.
∙ Insert the plug into the wall outlet and put
the switch to the required setting.
∙ Feed the clean, pre-cut fruit or vegetable
pieces down the feeder tube while the
unit is running. Use the pestle to push the
pieces down, lightly, observing the guide
slots on the pestle. Caution: Excessive
pressure may result in damage to motor
or fi lter.
∙ When processing large quantities of fruit
or vegetables, the pulp container and
juice container must be emptied from time
to time as necessary.
∙ When emptying the pulp container, the lid
should also be freed of any pulp residue.
∙ After use, switch the appliance off and
remove the plug from the wall socket.
General Care and Cleaning
∙ Always remove the plug from the wall
socket and allow the appliance to cool
down before cleaning.
∙ Please note: the fi lter has small, sharp
points. There is a risk of injury.
∙ Do not use abrasives, harsh cleaning
solutions or hard brushes for cleaning.
∙ To avoid the risk of electric shock, do not
clean the drive unit with water and do not
immerse it in water.
∙ The drive unit may be wiped with a
slightly damp, lint-free cloth.
∙ The pulp container, fi lter holder, lid,
pestle, fi lling guard and juice container
