759461
11
Verklein
Vergroot
Pagina terug
1/11
Pagina verder
- 11 - 07/2019
Copyright © 2019, Fast ČR, a.s.
Wash both parts of the dust container under running water and dry it well.
Note:
The inside of the dust container does not need to be washed after every
use, it is sufficient to wipe it out with awet wiping cloth.
Tap out the dust filter and its holder or clean these parts using the brush F3. Check
the condition of the filter and if damaged, replace it with anew one. Insert the filter
back into the holder and into the dust container. Secure it in place by turning the
grip.
Insert the dust container back into the vacuum cleaner.
Attention:
Do not wash the dust container or the dust filter in adishwasher.
The dust filter must not be washed using water.
Before putting the vacuum cleaner back into operation, check
that the dust filter is in its location. Otherwise the vacuum
cleaner may be damaged.
MOP UNIT
After every dry or wet wiping, remove the mop fabric, wash it by hand in lukewarm
water with the addition of asmall amount of gentle washing powder and allow it
to dry naturally.
Slide the dust container E1 out of the water tank E2, open it and tip out any dirty
material. For hygiene reasons, we recommend doing this away from living areas.
Empty out the dust container after every use and clean it regularly.
Take the filter holder G1 and the dust filter G2 out of the dust container. Tap out the
dust filter and its holder or clean these parts using the brush. Check the condition
of the filter and if damaged, replace it with anew one. Insert the filter back into the
holder and into the dust container.
Wash the dust container under running water and dry it well.
Wipe the water tank using alightly dampened cloth and then wipe it dry. Take
special care to ensure that the contacts E6 are dry.
Return the closed dust container back into the water tank.
CENTRAL ROTARY BRUSH
Push on the latches H1 of the central rotary brush cover H2 and take the cover out
together with the brush.
Use adry wiping cloth to clean out the area in which the rotary brush is housed.
Clean out the suction hole as described in the previous paragraph.
Remove any dirt and material (dust, wound on hair, animal fur, etc.) from the rotary
brush and the bearings H4.
Reinsert the rotary brush and its cover.
SUCTION HOLE
The suction hole A20 is located underneath the central rotary brush A22, therefore,
take it out before cleaning the suction hole. With repeat use, dust and dirt may
accumulate around the suction hole, which may manifest itself through suction
decreased efficiency. Remove the dirt and dust from the suction hole using asoft
brush. Regularly clean the suction hole to ensure maximum suction power.
ROTARY BRUSHES
Take out the rotary brushes A12 and A16 by pulling them upwards. Remove any
dust and dirt from the location where the brushes were mounted.
Remove all dust and dirt from the brushes. If necessary you may wash the brushes
under running water. If the bristles were deformed while the vacuum cleaner was
running, dip them in warm water to allow them to return to their original shape.
Allow the brushes to dry before reattaching to the vacuum cleaner.
After cleaning them, reattach them.
Note:
The rotary brushes become worn out when used. After acertain time it
is necessary to replace the used brushes with new ones. To order new
brushes, please contact your vendor or an authorised service centre.
COMPLETE ROBOTIC VACUUM CLEANER
Regularly wipe the surface of the vacuum cleaner using asoft dry wiping cloth.
Clean the front swivel wheel, motorised wheels, suction hole, rotary brush and the
bottom sensors at least once per week or more frequently.
First remove any coarser dirt from the front swivel wheel and the motorised wheels.
Then clean them around their entire perimeter using alightly dampened cloth and
wipe them dry. Do not forget to also clean the area around the wheels.
Wipe the sensors on the underside of the vacuum cleaner using asoft dry wiping
cloth or cotton bud.
CHARGING STATION
At least once per week, clean the surface of the charging bast B4 including the
charging contacts B5 using asoft dry wiping cloth.
STORAGE
When not using the vacuum cleaner for an extended period of time, do the
following:
Clean the vacuum cleaner as described in chapter CLEANING AND MAINTENANCE.
Remove the battery from the vacuum cleaner as described in chapter INSERTING
AND REMOVING THE BATTERY.
Disconnect the charging station from the power socket.
Store the vacuum cleaner with all its accessories in adry, clean and cool place.
TECHNICAL SPECIFICATIONS
Robotic vacuum cleaner
Dimensions (diameter × height) .............................................................................. 335 × 79 mm
Weight ............................................................................................................................................... 2.5 kg
Operating time per single charge ........................................................................... up to 120 min
Operating time per single charge when mop is used ............................................90-110 min
Dust container capacity ........................................................................................................... 475 ml
Water tank capacity ........................................................................................................................ 0.2 l
Power adapter
Rated voltage range .................................................................................................... 100−240 VAC
Rated frequency....................................................................................................................... 50/60 Hz
Output ................................................................................................................................. 5 V, 1000 mA
Battery
Type ............................................................................................................................ 2,600 mAh Li-Ion
Charging time ................................................................................................................................... 4-6 h
Input ................................................................................................................................................. 5 V, 1 A
The declared noise emission level is lower than 65 dB(A), which represents alevel Aof
sound power with respect to areference sound power of 1 pW.
DISPOSAL OF USED BATTERIES
Prior to handing over the product at aspecialised collection facility, it is necessary to
ensure that the battery is removed. Prior to removing the battery, turn off the vacuum
cleaner using the main switch. Disconnect the battery using the reverse sequence to
that described in chapter INSERTING AND REMOVING THE BATTERY.
This symbol indicates that used batteries do not belong in ordinary
municipal waste. Hand over used batteries to designated collection
points for proper disposal. Correct disposal of batteries will help
prevent negative impacts on the environment and human health.
Disposal in other countries outside the European Union.
This symbol is valid in the European Union. If you wish to dispose of
used batteries, request the necessary information about the correct
disposal method from the local authorities or from your vendor.
INSTRUCTIONS AND INFORMATION REGARDING THE
DISPOSAL OF USED PACKAGING MATERIALS
Dispose of used packaging material at asite designated for waste in your municipality.
DISPOSAL OF USED ELECTRICAL AND ELECTRONIC EQUIPMENT
This symbol on products or original documents means that used
electric or electronic products must not be added to ordinary
municipal waste. For proper disposal, renewal and recycling hand over
these appliances to determined collection points. Alternatively, in
some European Union states or other European countries you may
return your appliances to the local retailer when buying an equivalent
new appliance. Correct disposal of this product helps save valuable
natural resources and prevents potential negative effects on the
environment and human health, which could result from improper waste disposal. Ask
your local authorities or collection facility for more details. In accordance with national
regulations penalties may be imposed for the incorrect disposal of this type of waste.
For business entities in European Union states
If you want to dispose of electric or electronic appliances, ask your retailer or supplier
for the necessary information.
Disposal in other countries outside the European Union.
This symbol is valid in the European Union. If you wish to dispose of this product,
request the necessary information about the correct disposal method from the local
council or from your retailer.
This product meets all the basic requirements of EU directives related to
it.
SENCOR hereby declares that radio device model number SRV 9250BK is in compliance
with directive 2014/53/EU.
The full wording of the EU Declaration of Conformity is available at the website:
www.sencor.eu.
11

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Sencor SRV 9250 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Sencor SRV 9250 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,74 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info