120
Troubleshooting Procedures (cont.)
Segway PT Will Not Power On
Problem:
Your Segway PT will not power on when you press the InfoKey Controller Power/Standby button.
Review the following service procedures prior to troubleshooting this problem:
• “Remove the Batteries” (p. 106)
• “Install the Batteries” (p. 22)
• “Replace the InfoKey Controller Battery” (p. 115)
Recommended Action:
1. Make sure your PT's Batteries are charged.
2. Make sure you are standing with the InfoKey Controller no further than 15 ft. (5 m) from your PT.
3. Tap the InfoKey Controller Power/Standby button and verify that the Link Signal icon appears in the InfoKey display (see "InfoKey
Controller," p. 127).
4. If no Link Signal icon is displayed or the display is blank (no information displayed), remove and reseat the InfoKey Battery.
5. Tap the InfoKey Controller Power/Standby button. If the InfoKey display is blank, replace the InfoKey Controller Battery.
6. If the Warning icon appears in the InfoKey Display when attempting to power on, see “Startup Error Conditions," (p. 127).
7. If your PT will still not power on, remove both PT Batteries and then reattach them.