46
12. Do not allow any water droplets to get inside housing. This will
cause the inside of the housing to fog.
13. Close housing lid tightly. Make sure there are no obstructions that
prevent the housing from closing. Make sure lid is tightly pressed
into housing, ( see picture).
14. Close housing latch. Make sure the lid is pressed flat and evenly
against the housing body. The housing may leak if the lid is not flat
against the housing when closed.
Test camera and housing
1. Press the external power button on the top of the housing to turn camera power on.
2. Press the shutter button on the outside of the housing to take a test picture.
3. The power or shutter button should have a smooth action and return to its original resting position
after pressing. It is normal to feel some resistance when pressing the power and shutter button.
4. Press and hold power button to turn camera power off. It is recommended to leave camera power
off until you’re ready to use camera to preserve battery power.
5. After 3 minutes the LCD and monitor will turn off, and the camera will in power save mode. To
re-activate power, push the SHUTTER BUTTON.
6. After 6 minutes the camera power will shut down. (15 minutes in SEA or EXT. FLASH mode). To
operate the camera, push the POWER BUTTON to turn on the camera.
Close housing lid tightly.
