781423
19
Verklein
Vergroot
Pagina terug
1/71
Pagina verder
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB | 19
5. Do not put hands or feet near rotating parts
6. Avoid contact with hot fuel, oil, exhaust fumes and
hot surfaces. Do not touch the engine or mufer.
These parts get extremely hot from operation.
They remain hot for a short time after you turn
off the unit. Allow the engine to cool before doing
maintenance or making adjustments.
7. If the machine should start to make an unusual
noise or vibration, immediately shut off the en-
gine, disconnect the spark plug wire, and check
for the cause. Unusual noise or vibration is gener-
ally warning of trouble.
8. Use only attachments and accessories approved
by the manufacturer. Failure to do so can result in
personal injury.
9. Maintain the machine. Check for misalignment or
binding of moving parts, breakage of parts and
any other condition that may affect the machine’s
operation. If damaged, have the machine repaired
before use. Many accidents are caused by poorly
maintained equipment.
10. Keep the engine and mufer free of grass, leaves,
excessive grease or carbon build up to reduce the
chance of a re hazard.
11. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
12. Never douse or squirt the unit with water or any
other liquid. Keep handles dry, clean and free
from debris. Clean after each use.
13. Observe proper disposal laws and regulations for
gas, oil, etc. to protect the environment.
14. Store idle machine out of the reach of children
and do not allow persons unfamiliar with the ma-
chine or these instructions to operate it. Machine
is dangerous in the hands of untrained users.
Instructions for maintenance
Before cleaning, repair, inspecting, or adjusting, shut
off the engine and make certain all moving parts have
stopped. Disconnect the spark plug wire, and keep
the wire away from the plug to prevent accidental
starting. Have your machine serviced by qualied
repair personnel using only identical replacement
parts. This will ensure that the safety of the machine
maintained.
Fuel Safety
1. Fuel is highly ammable, and its vapors can ex-
plode if ignited. Take precautions when using to
reduce the chance of serious personal injury.
2. When relling or draining the fuel tank, use an
approved fuel storage container while in a clean,
well-ventilated outdoor. Do not smoke, or allow
sparks, open ames or other sources of ignition
near the area while adding fuel or operating the
unit. Never ll fuel tank indoors.
3. Keep grounded conductive objects, such as tools,
away from exposed, live electrical parts and con-
nections to avoid sparking or arcing. These events
could ignite fumes or vapors.
4. Always stop the engine and allow it to cool before
lling the fuel tank. Never remove the cap of the
fuel tank or add fuel while the engine is running
or when the engine is hot. Do not operate the ma-
chine with known leaks in the fuel system.
5. Loose the fuel tank cap slowly to relieve any pres-
sure in the tank.
6. Never over ll fuel tank. Fill tank to no more than
12.5 mm (1/2below the bottom of the ller neck
to provide space for expansion as the heat of the
engine can cause fuel to expand).
7. Replace all fuel tank and container caps securely
and wipe up spilled fuel. Never operate the unit
without the fuel cap securely in place.
8. Avoid creating a source of ignition for spilled fuel.
If fuel is spilled, do not attempt to start the engine
but move the machine away from the area of spill-
age and avoid creating any source of ignition until
fuel vapors have dissipated.
9. Store fuel in containers specically designed and
approved for this purpose.
10. Store fuel in a cool, well-ventilated area, safely
away from sparks, open ames or other sources
of ignition.
11. Never store fuel or machine with fuel in the tank
inside a building where fumes may reach a spark,
open ame, or other sources of ignition, such as a
water heater, furnace, clothes dryer and the like.
Allow the engine to cool before storing in any en-
closure.
Instructions for use and maintenance of the ma-
chine
1. Never pick up or carry a machine while the engine
is running.
2. Do not force the machine. Use the correct ma-
chine for your application. The correct machine
will do the job better and safer at the rate for which
it was designed.
3. Do not change the engine governor settings GB
or over-speed the engine. The governor controls
the maximum safe operating speed of the engine.
4. Do not run the engine at a high speed when you
are not tilling.
19

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Scheppach SC40P bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Scheppach SC40P in de taal/talen: Nederlands, Duits, Engels, Frans als bijlage per email.

De handleiding is 7.62 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Scheppach SC40P

Scheppach SC40P Gebruiksaanwijzing - Deutsch, English, Français - 32 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info