699394
14
Verklein
Vergroot
Pagina terug
1/44
Pagina verder
12 VERSA Plus SATEL
The partitions to which you have access will be armed in full mode.
The reader in VERSA-LCDM-WRL keypad works when the device is running in the
active mode (starting from the keypad firmware version 2.02 2015-09-17).
6.3.3 Arming the selected partition
1. Indicate the partition which is to be armed (press one of the keys: - partition 1;
- partition 2).
2. Select the arming mode (press one of the keys: - full arming; - day arming;
- night arming). Backlight of the keys will start blinking, which indicates that the
code must be entered.
3. Enter the code.
4. Press the key or press again the key corresponding to the selected arming mode.
When the quick arming is available, the steps 3 and 4 are skipped.
6.3.4 Quick arming
The installer may permit arming without entering the code.
1. Indicate the partition(s) to be armed (press one of the keys: - partition 1; -
partition 2; or - both partitions).
2. Select the arming mode (press one of the keys: - full arming; - day arming;
- night arming).
You can switch the arming mode from the night mode to the full mode and from the
day mode to the full mode without entering the code. Otherwise, you will have to enter
the code – see “Arming the selected partition”.
The installer can configure the system so that the quick arming can be impossible, if
there is a violated zone in the partition, or a trouble has occurred in the system.
6.3.5 Arming without delay
When arming the system using one of the above mentioned methods, press and hold down
the arming mode selection key (
, or ) for about 3 seconds. The system will
become armed without delay, i.e. the delayed zones will act as instant ones (without any
exit/entry delay time).
In the day or night arming mode, the entry delay countdown may run, if the control
panel is so configured by the installer.
6.3.6 Information about bypassed zones
During an arming attempt you may get a message about bypassed zones in the partition. The
information will be displayed, if:
the control panel has been suitably configured by the installer,
you have the INSPECTION right.
The message is displayed in the following form:
“Bypassed zones 1=Arm 4=Bypasses” – if you have the ZONE INHIBITION right. You can:
– press the key to cancel the arming,
– press the key to proceed with the arming,
– press the key to start the INHIBIT function (see: “Zone inhibiting” p. 26).
14

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Satel Versa Plus bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Satel Versa Plus in de taal/talen: Engels als bijlage per email.

De handleiding is 0,77 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Satel Versa Plus

Satel Versa Plus Snelstart handleiding - Nederlands - 11 pagina's

Satel Versa Plus Gebruiksaanwijzing - Nederlands - 46 pagina's

Satel Versa Plus Aanvulling / aanpassing - Nederlands - 110 pagina's

Satel Versa Plus Aanvulling / aanpassing - Nederlands - 2 pagina's

Satel Versa Plus Installatiehandleiding - Nederlands - 36 pagina's

Satel Versa Plus Snelstart handleiding - Deutsch - 12 pagina's

Satel Versa Plus Aanvulling / aanpassing - Deutsch - 113 pagina's

Satel Versa Plus Gebruiksaanwijzing - Deutsch - 46 pagina's

Satel Versa Plus Installatiehandleiding - Deutsch - 36 pagina's

Satel Versa Plus Aanvulling / aanpassing - English - 110 pagina's

Satel Versa Plus Installatiehandleiding - English - 36 pagina's

Satel Versa Plus Snelstart handleiding - English - 11 pagina's

Satel Versa Plus Installatiehandleiding - English - 32 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info