699459
36
Verklein
Vergroot
Pagina terug
1/42
Pagina verder
34 VERSA SATEL
Edit users – when the option is enabled, the person using the service code can add, edit and
remove users.
Arm/Dis/Clr/Bps – when the option is enabled, the person using the service code can arm
and disarm the system, clear alarms, and bypass zones (inhibit or isolate).
6.22.2 Defining the service access time
The function is available when the PERMANENT ACCESS option is disabled (see: “Defining the
service access rules”).
Enter the user menu and press in turn . The number of remaining hours
will be displayed, during which the access to the alarm system is still possible by using the
service code. Enter a new value from the range of 0 to 255 hours and press
.
6.22.3 Replacing batteries in wireless keypad
The function is available if a wireless keypad is installed in the alarm system. The function is
supported by ACU-120 / ACU-270 controller with firmware version 5.03.
1. Enter the user menu and press in turn
.
2. Keep pressing or until the name of the keypad in which you want to replace
the battery is displayed.
3. Press . The status of tamper switch in the keypad will not be checked for 3 minutes,
which allows you to replace the battery.
7. Operating the alarm system by means of keyfob
The alarm system can be operated by means of keyfobs, if the 433 MHz keyfobs receiver
expansion module (INT-RX-S / INT-RX), 433 MHz wireless system controller (VERSA-MCU)
or ABAX wireless system controller (ACU-120 / ACU-270 / ACU-100 / ACU-250) is
connected to the control panel.
The user can have two keyfobs:
433 MHz keyfob – supported by the 433 MHz keyfobs receiver expansion module or 433
MHz wireless system controller,
APT-100 bidirectional keyfob – supported by the ABAX wireless system controller.
A single keyfob enables up to 6 functions to be executed. The list of functions assigned to the
buttons / combination of buttons should be obtained from the person who configured the
keyfob settings when adding / editing a user. In the case of APT-100 keyfob, that person
should also provide information about functionality of the LEDs. The keyfob LEDs can be
used to confirm execution of functions, as well as to indicate the system status (pressing
a button on the APT-100 keyfob is accompanied by the LEDs flashing rapidly three times,
and in a little while the LED(s) may come on for 3 seconds to provide information).
The installer can configure the alarm system so that the sirens connected to the
system outputs can inform the user about the following events:
1 tone – starting the arming procedure (which is equivalent to arming, if the exit delay
has not been programmed),
2 tones – disarming,
4 tones – alarm clearing,
7 tones – arming is not possible, or the arming procedure has failed.
Tone duration is approx. 0.3 seconds.
36

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Satel VERSA 10 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Satel VERSA 10 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,76 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Satel VERSA 10

Satel VERSA 10 Snelstart handleiding - Nederlands - 11 pagina's

Satel VERSA 10 Gebruiksaanwijzing - Nederlands - 44 pagina's

Satel VERSA 10 Snelstart handleiding - Nederlands - 2 pagina's

Satel VERSA 10 Aanvulling / aanpassing - Nederlands - 86 pagina's

Satel VERSA 10 Installatiehandleiding - Nederlands - 35 pagina's

Satel VERSA 10 Snelstart handleiding - Nederlands - 2 pagina's

Satel VERSA 10 Snelstart handleiding - Deutsch - 11 pagina's

Satel VERSA 10 Aanvulling / aanpassing - Deutsch - 89 pagina's

Satel VERSA 10 Gebruiksaanwijzing - Deutsch - 44 pagina's

Satel VERSA 10 Installatiehandleiding - Deutsch - 37 pagina's

Satel VERSA 10 Snelstart handleiding - Deutsch - 2 pagina's

Satel VERSA 10 Snelstart handleiding - English - 11 pagina's

Satel VERSA 10 Aanvulling / aanpassing - English - 87 pagina's

Satel VERSA 10 Installatiehandleiding - English - 36 pagina's

Satel VERSA 10 Gebruiksaanwijzing - English - 32 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info