699548
12
Verklein
Vergroot
Pagina terug
1/52
Pagina verder
10 MICRA SATEL
4. Connect the terminals of transformer secondary winding to the AC terminals on module
electronics board.
5. Connect the battery to the dedicated leads (red one to the battery “plus”, black one to
“minus”). The module will not start after connecting the battery alone. The battery
cable ends must not be cut off.
6. Turn on 230 V AC power supply in the circuit to which the transformer is connected. The
module will start operating.
The above mentioned power-up sequence (battery first, 230 V AC mains after) will
permit proper operation of the power supply unit and electronic protection circuits, thus
preventing defects which might be caused by possible installation errors. Should
a situation occur when the power supply has to be entirely disconnected, disconnect
first the AC voltage and then the battery.
7. Connect the computer to the module RS-232 (TTL) port (see: section "Local programming
through RS-232 (TTL) port").
8. Turn on the module power supply.
9. Using the GPRS-S
OFT
program, define PIN code for the SIM card (if the card requires
entering the PIN code) to be installed in the module.
10. Turn off the module power supply.
11. Insert the nano-SIM card into the socket (see: Fig. 7).
Fig. 7. Installing the SIM card.
12. Turn on the module power supply. Logging the telephone into the GSM network may take
a few minutes.
If the SIM card PIN code is inconsistent with that defined in module settings, the
inconsistency will be indicated by the electronics board LEDs (see: Fig. 2 Example F).
The second attempt of using the PIN code will be made after 30 seconds. After
the third attempt to use the invalid PIN code, the SIM card will be blocked. In order to
enter the PUK code and unblock the SIM card, remove it and insert into the mobile
phone.
3.8 WIRELESS DEVICES INSTALLATION
Installation of the wireless devices may only begin after starting the module, when it is
possible to check the quality of communication between the wireless devices and the
module. If transmissions from the intended place of installation fail to reach the module, you
should choose a different installation location. Sometimes, you just need to move the device
from ten to twenty centimeters for the transmissions to be correctly received by the module.
Only then you can install the device permanently.
The MICRA module supports:
1. wireless detectors:
MSD-300 smoke and heat detector,
MPD-300 passive infrared detector,
– MMD-300 magnetic contact,
MMD-302 magnetic contact with input for roller shutter detector,
12

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Satel MICRA bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Satel MICRA in de taal/talen: Engels als bijlage per email.

De handleiding is 0,9 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Satel MICRA

Satel MICRA Gebruiksaanwijzing - Nederlands - 52 pagina's

Satel MICRA Gebruiksaanwijzing - Deutsch - 52 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info