699075
92
Verklein
Vergroot
Pagina terug
1/114
Pagina verder
90 Programming SATEL
ASW-210
For each position occupied by the controller, enter 0 (relay can only be controlled via the
control panel), 1 (the input enables relay to be controlled with monostable switch) or 2 (the
input enables relay to be controlled with bistable switch).
9.2.2 Configuring the wireless devices – LCD keypad
Having started the CONFIGURATION function (STRUCTURE HARDWARE EXPANDERS
SETTINGS ABAX - INTEGRA. CONFIGURATION), use the and keys to select the zone
to which the do wireless device is assigned and press the
key. Use the arrow keys for
programming. The values which can be programmed for individual parameters of wireless
devices are presented in the section describing configuration of the devices by means of the
DLOADX program.
9.3 Specific character of the operation of wireless devices
This chapter describes the peculiar character of the operation of individual groups of wireless
devices, which affects the method of programming the zones and outputs to which the
wireless devices are assigned.
9.3.1 Wireless detectors
The zone to which a wireless detector is assigned is activated when the detector reports
alarm (select the appropriate zone type). If a detector tamper is to trigger the tamper alarm,
program the zone as 2EOL/NC or 2EOL/NO.
The mode of operation of wireless detectors depends on the status of partition to which the
zone with wireless detector belongs:
partition disarmed the detector operates in passive mode. This operating mode prolongs
the battery life. Detector informs the control panel about its status during polling (only the
tamper information is sent immediately).
partition armed the detector operates in active mode. The detector sends immediately all
information to the control panel.
Because switching the detectors over from the passive into active mode and conversely
takes place during the response time, it is performed with some delay in relation to
arming/disarming. The maximum delay depending on the selected response frequency
can be 12, 24 or 36 seconds.
The wireless detectors assigned to the 24-hour zones, which are permanently armed, are in
the active mode at all times. Also other wireless detectors can always work in the active
mode, if the ALWAYS ACTIVE option is enabled for them (see p. 85).
According to the EN50131-3 standard all ABAX 2 / ABAX Hold-Up devices must be
always in active mode.
The battery life time in the detectors switched permanently into the active mode is
shorter than in those which are periodically switched to the passive mode. However, if
the specific character of a detector or its installation place is such that the number of
alarms is low, switching the detector permanently into the active mode will not have
a significant effect on the battery life.
9.3.2 Wireless sirens
Turning on the output to which the wireless siren is assigned will trigger the signaling.
Depending on the siren:
ASP-105 the first output controls acoustic signaling, and the other one optical signaling.
The command to start or stop the signaling is sent to the siren immediately. The acoustic
92

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Satel Integra 64 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Satel Integra 64 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,32 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Satel Integra 64

Satel Integra 64 Gebruiksaanwijzing - Nederlands - 52 pagina's

Satel Integra 64 Snelstart handleiding - Nederlands - 24 pagina's

Satel Integra 64 Aanvulling / aanpassing - Nederlands - 121 pagina's

Satel Integra 64 Installatiehandleiding - Nederlands - 35 pagina's

Satel Integra 64 Aanvulling / aanpassing - Deutsch - 121 pagina's

Satel Integra 64 Gebruiksaanwijzing - Deutsch - 54 pagina's

Satel Integra 64 Installatiehandleiding - Deutsch - 38 pagina's

Satel Integra 64 Snelstart handleiding - Deutsch - 2 pagina's

Satel Integra 64 Gebruiksaanwijzing - English - 51 pagina's

Satel Integra 64 Installatiehandleiding - English - 36 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info