699075
37
Verklein
Vergroot
Pagina terug
1/114
Pagina verder
SATEL INTEGRA 35
computer port to which the control panel is connected. Then, follow the procedure described
in section Starting the service mode “from pins”(p. 6).
Running the local programming from pins is not possible, if the DISABLE
DOWNLOADING option is enabled.
3.3.3 Finishing local programming
To end the local programming you can use the END DWNL-RS function ([service code]
DOWNLOADING END DWNL-RS).
The local programming function will be finished automatically after 255 minutes have elapsed
since the last use of the DLOADX program, and the service access was blocked or expired
during that time.
The local programming function must be disabled, if the control panel is to
communicate through the RS-232 port with an external analog modem, GSM module,
INT-GSM module or ETHM-1 / ETHM-1 Plus module (e.g. during remote
programming, event reporting, etc.).
3.4 Remote programming
3.4.1 Starting remote programming via modem
The control panel has a built-in 300 bps modem. The GSM communicator of
INTEGRA 128-WRL control panel supports sending data with the use of CSD technology, i.e.
at a rate of 9600 bps. In case of the other control panels, higher transmission rates can be
obtained after an external modem is connected. For information on how to connect the
external modem to the control panel please refer to the INSTALLER MANUAL. Initializing the
modem connection is possible, if there is a properly matched modem on the computer side
(see Table 4).
Configuration on control panel side Configuration on computer side
Built-in 300 bps modem Analog modem
External analog modem
Analog modem
GSM modem
External ISDN modem
ISDN modem
GSM modem
External or built-in GSM modem
Analog modem
GSM modem
Table 4. Selecting control panel and computer modems.
Communication can be established in several ways (shown in parentheses is information
about requirements on the control panel side):
1. Connection initialized from the DLOADX program (built-in modem 300 bps or external
analog modem). This method makes it possible to establish connection with the control
panel from any location. Establishing connection by this method is possible, if the
computer telephone number has not been programmed in the control panel.
2. Connection initialized from the DLOADX program, but the control panel calls back and
sets up the connection (built-in 300 bps modem or external analog modem). The control
panel may only be remotely programmed from a specified locality.
3. Connection initialized by means of SMS (INTEGRA 128-WRL control panel or SATEL
GSM module operating as an external modem).
37

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Satel Integra 64 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Satel Integra 64 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,32 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Satel Integra 64

Satel Integra 64 Gebruiksaanwijzing - Nederlands - 52 pagina's

Satel Integra 64 Snelstart handleiding - Nederlands - 24 pagina's

Satel Integra 64 Aanvulling / aanpassing - Nederlands - 121 pagina's

Satel Integra 64 Installatiehandleiding - Nederlands - 35 pagina's

Satel Integra 64 Aanvulling / aanpassing - Deutsch - 121 pagina's

Satel Integra 64 Gebruiksaanwijzing - Deutsch - 54 pagina's

Satel Integra 64 Installatiehandleiding - Deutsch - 38 pagina's

Satel Integra 64 Snelstart handleiding - Deutsch - 2 pagina's

Satel Integra 64 Gebruiksaanwijzing - English - 51 pagina's

Satel Integra 64 Installatiehandleiding - English - 36 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info