699622
5
Verklein
Vergroot
Pagina terug
1/6
Pagina verder
SATEL ACX-220 3
C1...C4 - relay output common contact.
NC1...NC4 - relay output normally closed contact.
NO1...NO4 - relay output normally open contact.
4. Installation
Disconnect power before making any electrical connections.
The ACX-220 expander should be installed indoors, in spaces with normal air humidity.
Remember that thick walls, metal partitions, etc. will reduce the range of the radio signal. It is
recommended that the expander be mounted high above the floor. This will allow you to get
a better range of radio communication and avoid the risk of the expander being accidentally
covered by people moving around the premises. Installing the device in close vicinity of
electrical systems is not recommended, since it can adversely affect the range of radio
signal.
The expansion module can be supplied from a power supply unit connected to the APS
connector (e.g. from the APS-412 power supply offered by SATEL) or, alternatively, from the
+12V and COM terminals. In the latter case, the control panel, expander with power supply,
or power supply with a 3 A current limiter can serve as a power source.
If a power supply unit is connected to the APS connector, the expander will send
information about the following power supply unit troubles:
- loss of 230 V AC mains,
- low battery,
- power supply overload.
1. Loosen the screws locking the enclosure cover and remove the cover.
2. Connect the temporary 12 V DC power supply to the expander.
3. Add the expander to the wireless system (see the ABAX 2 / ABAX controller manual or
the INTEGRA 128-WRL control panel installer manual). The sticker with serial number
which shall be entered when registering the expander in the system can be found on the
electronics board.
In the INTEGRA / VERSA alarm system, the expander is identified as ACX-201.
Simultaneous operation of the expander by the ABAX 2 and ABAX controller /
INTEGRA 128-WRL alarm control panel is not possible.
4. Place the expander in the location intended for its installation.
5. Check the level of signal received from the expander by the ABAX 2 / ABAX controller or
the INTEGRA 128-WRL control panel. If the signal level is lower than 40%, select
another place for installation. Sometimes, it is sufficient to shift the device ten or twenty
centimeters to obtain a considerable improvement in the signal quality.
The ARF-200 tester makes it possible to check the radio signal strength at the place of
future installation without having to put the expander there.
6. Disconnect the temporary 12 V DC power supply.
7. Make a hole for the bunch of wires in the enclosure base.
8. Run the wires through the hole (power cables, cables connecting wired devices with the
expander, etc.).
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Satel ACX-220 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Satel ACX-220 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,09 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Satel ACX-220

Satel ACX-220 Gebruiksaanwijzing - Nederlands - 6 pagina's

Satel ACX-220 Snelstart handleiding - Nederlands - 2 pagina's

Satel ACX-220 Gebruiksaanwijzing - Deutsch - 6 pagina's

Satel ACX-220 Snelstart handleiding - Deutsch, English - 2 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info