10
Part Names and Functions
A built-in micro processor which controls this unit may occasionally
malfunction and need to be reset. This can be done by pressing the
RESET button with a pen, which will shut down and restart the unit. Do
not use the RESET function excessively.
q COMPUTER IN 1 DVI-I
Connect computer output (Digital/Analog DVI-I type) or Multi
Card Imager (optional) to this terminal. (p17, 18)
Terminal
q w e r t
y u i o
i S-VIDEO
Connect the S-VIDEO output from video equipment to this jack.
(p18)
r AUDIO IN
Connect the audio output from video equipment connected to
t or i to this jack. (When the audio output is monaural,
connect it to L (MONO) jack.) (p18)
o AUDIO IN 1 and 2
Connect the audio output (stereo) from a computer or video
equipment connected to
q or e to these jacks. (p17, 18)
e COMPUTER IN 2 / MONITOR OUT
This terminal is switchable and can be used as computer input,
RGB Scart 21-Pin Video input, or monitor output. Set the
terminal up as either Computer input or Monitor output properly
before using this terminal. An optional cable is required when
using this terminal as RGB Scart 21-Pin Video input. (p17, 18)
(This terminal outputs analog signal from COMPUTER IN 1 DVI-I
terminal only when using as Monitor out.)
!0 AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this jack. (p17, 18)
This terminal outputs sound from AUDIO IN terminal
r or o.
t VIDEO
Connect the composite video output from video equipment to
VIDEO/Y jack or connect component video output from video
equipment to VIDEO/Y, Pb/Cb and Pr/Cr jacks. (p18)
w SERVICE PORT
This jack is used to service this projector.
*
*
Do not press this button. This button
is used for optional accessories.
!00
y USB (Series B)
When operating the connected computer with the remote
control, connect USB port of your computer to this connector
with a USB cable. (p17)
u USB (Series A)
Connect the Projector USB key (Optional accessories). (p57)
