53
Setting
PIN Code Change
Logo PIN code can be changed to your desired four-digit number.
Select "PIN code change" with the Control pad and press the
SELECT button. Set a new Logo PIN code.
Be sure to note the new Logo PIN code and keep it at hand. If
you lost the number, you could no longer change the Logo PIN
code setting. For details on PIN code setting, refer to relevant
instructions of the PJ Lock function on page 57.
Background
3 background settings are available in this projector. Select one of
the followings when no input source is connected to the projector
or no input signal is coming from the connected equipment:
Blue . . . . . .blue colored background
My logo . . .the image you captured
Black . . . . .black colored background
Lamp
Control
This feature allows you to change brightness of the screen.
Normal
. .normal brightness
Auto . . . .
brightness according with the input signal
Eco
. . . .lower brightness reduces the lamp power
consumption and extends the lamp life.
Mode
This projector is equipped with two lamps. Mode setting allows
you to switch using 1 lamp or 2 lamps.
2-lamp . . . .lights both of the lamps inside the projector.
1-lamp . . .lights a lamp only. Auto, Lamp1, or Lamp2 can be
altered.
PIN Code change Dialog Box
Pointer
Select PIN code change and
press the SELECT button.
The PIN code input dialog box
will appear.
Lamp Control
✔Note:
• When neither of the two lamps is lighted, the projector will shutdown automatically.
• When either of the two lamps does not light up, the LAMP 1/2 REPLACE indicator
is blinking red and the projector will light the other automatically.
Setting
Lamp Mode
When selecting Auto in 1-Lamp
mode, the projector automatically
selects either lamp of which the
total Lamp time is shorter and
lights it up.
✔Note:
When using 100 W (optional) lamps, the Lamp control setting cannot be altered.
Remote control
Four remote control channels and eight remote control ID are
prepared for the projector to prevent radio frequency interference
from the other equipment and mutual interference between
projectors when using them at the same time.
For example, operating the projector in “CH-2 and ID-7,” both the
projector and the remote control must be switched to “CH-2 and
ID-7.”
To change CH and ID for the projector;
Select a remote control CH and ID in this Setting menu.
To change CH and ID for the remote control;
While holding down the CH or ID button, press the SELECT
button. The remote control CH or ID switches sequentially for
one pressing the SELECT button. Changing CH and ID should be
done separately. (See page 16 and 17 for details.)
Remote control
When pressing the SELECT button at Remote control,
the remote control CH and ID menu appears. Select CH
and ID respectively.
The setting
selected.
Pointer
