6
Need help?
Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032
3
CHANNEL SEARCH
When the television is powered on
for the first time, it automatically
checks for the presence of an RF
signal.
•
Press the POWER key to turn
on the DTV.
•
Then press the CHANNEL
UP key to automatically
search for available channels:
Digital (ATSC) and Analog (NTSC).
The Channel Search contains two processes that are
executed simultaneously for digital and analog
channels.
NOTES:
The on-screen message for digital search will appear with a
progress bar and percentile number displayed across the
bottom of the screen (to indicate activity) as the search process
continues. (Channel numbers will appear under the progress
bar only when a digital channel is found.)
Channel information found during the channel search is
stored in the Channel Scan Memory database. After the
channel search is completed, the DTV will tune to the lowest
Digital channel or lowest Analog channel if no digital channels
are found.
If the DTV does not detect any
digital or analog channels, a
message advising the viewer
to check the cables and
antenna connections will
appear. In this case, you must
press the CHANNEL UP key
again to repeat the channel
search process. If after two
searches the DTV still fails to detect any channels, the DTV
will tune to analog channel 3. These two channel searches
are necessary even if you plan to use the DTV only as a
monitor.
If no analog or digital channels are found after the
second search, Channel Search will default to off-air analog
channels 2 through 69 and digital channel D3-1. Select analog
channels using the remote control keypad. See page 11, item
number 3.
4
AUTO CLOCK SETTING (Optional)
After channel search is complete, the DTV will begin
Auto Clock setting. This feature searches for a local
PBS station that is broadcasting an extended data
service signal. This signal is used to automatically
set the clock/day. (This
may take several
seconds.) To cancel auto
clock setting, press the
CHANNEL UP key. (To
set the clock manually,
see page 19.)
5
ANTENNA SELECTION (Optional)
To change the initial ANALOG tuning system setup
(from antenna to cable or cable to antenna), use
the on-screen menu. See “Antenna Selection” on
page 15.
2
INSTALL TWO “AAA” BATTERIES
IMPORTANT NOTE: Spent or discharged batteries must be recycled
or disposed properly in compliance with all applicable laws. For
detailed information, contact your local County Solid Waste
Authority.
•
Install two “AAA” Batteries
(not included) so that the
“+” and “–” marks on the
batteries match the “+”
and “–” marks inside
the Remote.
To review the Remote
functions, go to
Pages 11 ~ 12.
■
Remove the batteries if the remote control will not be used for a
month or more. Weak batteries may leak and cause damage.
(Normal battery life is roughly six months.)
■
If batteries have leaked in the Remote Control Unit, carefully wipe
the case clean and load new batteries.
