Some Digital Terrestrial channels operate
on a Pay Per View basis. These require a
subscription and a hardware decoder.
Obtain the Conditional Access Module (CAM)
and the viewing card by subscribing to a pay
channel company, then insert those to the TV
using the following procedure.
• Switch off the TV and unplug from the
mains.
• Insert the CAM and then the viewing card to the
slot that is located in the terminal cover at the
left-hand side of the TV (from front view).
• The CAM should be correctly inserted, it is
impossible to insert fully if reversed. The CAM
or the TV terminal may be damaged if the CAM
is forcefully inserted.
• Connect the TV to the mains supply, switch
on and then wait for few moments until the
card is activated.
• Some CAMs may require the following set
up. Please set the CAM by entering the IDTV
menu, Conditional Access then pressing the
OK button. (CAM set up menu is not displayed
when it is not required.)
• To see the viewing contract information:
enter IDTV; press the “ MENU ” button, then
highlight Conditional Access and press the
OK button.
• When no module is inserted, “No Conditional
Access module detected” message appears
on the screen.
• Refer to the module instruction manual for
details of the settings.
NOTE: Insert or remove the CI module only when the
TV is in STAND-BY mode or SWITCHED OFF.
TV Setup
You can use this item to display the TV
functions.
The digital TV Setup menu screen is accessed
from the main menu. Press the “M” button to
display the main menu and use “ ” or “ ” button
to highlight “TV Setup”, press the OK button to
display TV Setup menu screen.
You can ¿ nd detailed information for all menu
items in “Analogue TV Menu System” section.
Setup
The adjustments in this menu are given as the
following:
Con¿ guration
You can con¿ gure the settings of your TV. Select
Con¿ guration from Setup menu and press OK
to view this menu. Press the RETURN button
on the remote control to exit.
Dolby Digital (* for EU countries only)
In the Con¿guration Menu, highlight the Dolby
Digital item by pressing “ ” or “ ” buttons.
Use the “ ” or “ ” buttons to set the Dolby
Digital as On or Off. If the channel that you are
