532739
9
Verklein
Vergroot
Pagina terug
1/49
Pagina verder
DISMANTLING
If one of the motors cannot be made
to operate correctly, use of that motor
can be “disabled” by setting the
corresponding switch on the board
(SW1: switches 1 and 2 for motors 1
and 2).
The motor thus “disabled” can be
removed. The unit operates on
the other motor.
16
WORK THAT MAY BE REQUIRED
15
ELECTRICAL INSTALLATION MUST BE CARRIED
OUT BY A PROFESSIONAL ELECTRICIAN
Before carrying out any other types of work, disconnect
the Sanicubic Classic from the power supply.
UK
INSTRUCTIONS ONLY FOR QUALIFIED
PROFESSIONAL SPECIALISTS
A
LARM ON APPLIANCE
REMOVING A MOTOR
D
ISCONNECT THE UNIT FROM THE POWER
S
UPPLY (the yellow indicator light must be flashing off).
INSTRUCTIONS RESERVED EXCLUSIVELY
FOR QUALIFIED PROFESSIONAL SPECIALISTS
F
1
16
5
16
Unclip the cover.
Unscrew the collar on the
faulty motor (the check valve
stays in place while the motor
is being repaired).
A
Unscrew the collar .
Remove the motor power
wires from the screw
connector.
C
B
Remove the screws from
the inspection cover.
Use the handle to lift the
motor carefully.
E
D
Please contact the service
engineer. You can operate the
lifting station in minimum confi-
guration with just one motor.
Remove the screws of
the faulty motor from the
inspection cover.
F
Put the inspection cover back
in place.
Reconnect the discharge pipe.
Use the plug to close off
the motor cable outlet in the
inspection cover. Fix using
the hose clip .
B
G
Operations on the electronic
board (cf. illustration
):
set the switch corresponding
to the number of the faulty
motor from ONto OFF:
1 = motor 1
2 = motor 2
In this configuration, the unit
will not switch to “alarm”
status and the electronic
board only powers the motor
remaining in place.
PUTTINGTHEMOTOR
BACK INPLACE
Remove the plug and the
inspection cover.
Screw the motor onto the
inspection cover and put the
cover back in place.
Reconnect the motor power
wires (cf. illustration ).
Warning:
Comply carefully with the
colour code:
Blue wire with the blue wire
Brown wire with the brown
wire
Green wire with the green
wire
White wire with the white
wire
Set the motor switch on the
board to ON.
Reconnect the discharge
pipe.
Connect the unit to the
power supply.
Carry out a complete test
for commissioning (cf.
paragraph ).
11
3
16
G
1
1
6
The unit beeps to show that it
is no longer under power.
Firstinterventionsontheappliance
(*) Warning: if pumping height is high, 90° elbows should be avoided.
MO: Manual Over ride
INDICE
01.12
A
B
C
D
E
G
2
16
3
16
4
16
6
1
6
PROBABLE CAUSES
faulty electronic board
Outlet pipe blocked
Discharge head too high
Faulty detection system
•faulty electronic board
Check valves either leak or
are broken
ACTION TO BE TAKEN
Consult the SFA customer
services
Unblock the outlet pipe
Check the installation (*)
Consult the SFA customer
services
Clean or change check valves
Second interventions on the appliance
FAULT
1 Alarm + general alarm LED
flashing
2 Alarm + general alarm LED
lit
3 general alarm LED
4 Alarm + general alarm LED
+ yellow mains LED flashing
PROBABLE CAUSES
Faulty detection system
Blocked pipe
Pump blocked or seized
The appliance has the follo-
wing problem: blocked pipe,
seized or blocked pump(s)
The appliance has been
affected by a mains power cut
Mains power cut
ACTION TO BE TAKEN
Consult the SFA customer
services
Make the pumps work (MO
button) in several bursts.
Consult an SFA approved
engineer
Press on one of the two MO
buttons to reset (alarm stops)
To stop the alarm, press on
one of the two MO buttons
Check the electrical system
Consult the SFA customer
services
FAULT
The motor does not start but
the MF works
Pumps on constantly
Pumps work intermittently
N°163 PRO SANICUBIC 2 Classic
N163 R4LC Feuillet SPECIAL PRO Sanicubic 2 Classic:5622 NOTICE N°129 EXE 30/01/12 17:44 Page 2
9

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Sanibroyeur SANICUBIC 2 Classic Expert-line bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Sanibroyeur SANICUBIC 2 Classic Expert-line in de taal/talen: Alle talen als bijlage per email.

De handleiding is 9,99 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info