630503
280
Verklein
Vergroot
Pagina terug
1/291
Pagina verder
280 • IRC (Inter-Register Communications) Appendix SAM4s SPS-300 Operator's & Programming Manual v1.4
N
O
TE
N
O
TE
N
O
TE
Ethernet Cable Termination Instructions
1. Pull the cable off the reel to the desired length and cut. If you are pulling cables
through holes, it is easier to attach the RJ-45 plugs after the cable is pulled. The total
length of wire segments between an SPS-2000/SPS-5X0 and a switch or between two
ECRs cannot exceed 100 Meters (328 feet).
2. Start on one end and strip the cable jacket off (about 1") using a stripper or a knife.
Be extra careful not to nick the wires, otherwise you will need to start over.
3. Spread, untwist the pairs, and arrange the wires in the order of the desired cable end.
Flatten the end between your thumb and forefinger. Trim the ends of the wires so
they are even with one another, leaving only 1/2" in wire length. If it is longer than
1/2" it will be out-of-spec and susceptible to crosstalk. Flatten and insure there are no
spaces between wires.
4. Hold the RJ-45 plug with the clip facing down or away from you. Push the wires
firmly into the plug. Inspect each wire is flat even at the front of the plug. Check the
order of the wires. Double check again. Check that the jacket is fitted right against
the stop of the plug. Carefully hold the wire and firmly crimp the RJ-45 with the
crimper.
5. Check the color orientation. Check that the crimped connection is not about to come
apart, and check to see if the wires are flat against the front of the plug. If even one of
these is incorrect, you will have to start over. Test the Ethernet cable.
Ethernet Cable Tips
A crossover is used to connect two Ethernet devices without a switch.
A crossover has one end with the Orange set of wires switched with the Green set.
Odd numbered pins are always striped, even numbered pins are always solid colored.
Looking at the RJ-45 with the clip facing away from you, Brown is always on the
right, and pin 1 is on the left.
No more than 1/2" of the Ethernet cable should be untwisted otherwise it will be
susceptible to crosstalk.
Do not deform, do not bend, do not stretch, do not staple, do not run parallel with
power cables, and do not run Ethernet cables near noise inducing components.
Routing Communication Cable
Communication cable must be kept a minimum of one (1) foot away from AC wiring or
fluorescent lighting and at least five (5) feet away from large transformers or motors. If
the communication cable must cross AC wiring, it must cross at a 90 angle to the AC
wiring.
Metal Conduit should be used wherever there is a chance of damage to the wire
including telephone rooms and basements (where rodents could pose a problem). This
conduit should be attached to the building ground not the isolated ground.
Communications cable must NOT be placed alongside or in the same conduit as AC
power or telephone signals.
The bending radius on CAT 5e UTP or STP cable is to be a minimum of 1 inch.
280

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Samsung Sam4S SPS-320 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Samsung Sam4S SPS-320 in de taal/talen: Engels als bijlage per email.

De handleiding is 2,65 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Samsung Sam4S SPS-320

Samsung Sam4S SPS-320 Gebruiksaanwijzing - Nederlands - 48 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info