Safety information _3
compatibility that is, however, also combustible.
When transporting and installing the appliance,
care should be taken to ensure that no parts of
the refrigerating circuit are damaged.
SEVERE WARNING SIGNS
FOR INSTALLATION
• Do not install this appliance in a humid, oily
or dusty location, in a location exposed to
direct sunlight and water (rain drops).
- Deteriorated insulation of electrical parts may
cause an electric shock or fi re.
• Do not place this refrigerator in direct sunlight or
expose to the heat from stoves, room heaters or
other appliances.
• Do not plug several appliances into the same
multiple power board.
The refrigerator should always be plugged into
its own individual electrical outlet which has a
voltage rating that matched the rating plate.
- This provides the best performance and also
prevents overloading house wiring circuits, which
could cause a fi re hazard from overheated wires.
If the wall socket is loose, do not insert the
power plug.
- There is a risk of electric shock or fi re.
• Do not use a cord that shows cracks or abrasion
damage along its length or at either end.
• Do not bend the power cord excessively or
place heavy articles on it.
• Do not use aerosols near the refrigerator.
- Aerosols used near the refrigerator may cause
an explosion or fi re.
• Do not install this appliance in a location where
gas may leak.
- This may result in an electric shock or fi re.
• The installation or any service of this
appliance is recommended by a qualifi ed
technician or service company.
-
Failing to do so may result in an electric shock, fi re,
explosion, problems with the product, or injury.
• This refrigerator must be properly installed and
located in accordance with the manual before it
is used.
• Connect the power plug in proper position with
the cord hanging down.
-
If you connect the power plug upside down, wire
can get cut off and a cause fi re or an electric shock.
• Make sure that the power plug is not squashed
or damaged by the back of the refrigerator.
• When moving the refrigerator, be careful not to
roll over or damage the power cord.
- This constitutes a fi re hazard.
• The appliance must be positioned so that the
plug is accessible after installation.
• The refrigerator must be grounded.
- You must ground the refrigerator to
- prevent any power leakages or electric shocks
caused by current leakage from the refrigerator.
• Never use gas pipes, telephone lines or other
potential lightening rods as ground.
- Improper use of the ground plug can result in an
electric shock.
• If the power cord is damaged, have it
replaced immediately by the manufacturer
or its service agent.
• The fuse on the refrigerator must be changed by
a qualifi ed technician or service company.
- Failing to do so may result in an electric shock or
personal injury.
Contact with a service center if any damage is
found after removing the packing materials.
CAUTION SIGNS FOR
INSTALLATION
•
Keep ventilation opening in the appliance
enclosure or mounting structure clear of
obstruction.
• Allow the appliance to stand for 2 hours after
installation.
SEVERE WARNING SIGNS
FOR USING
•
Do not insert the power plug with wet hands.
• Do not store articles on the top of the
appliance.
- When you open or close the door, the articles
may fall and cause a personal injury and/or
material damage.
•
Do not put items fi lled with water on the refrigerator.
- If spilled, there is a risk of fi re or electric shock.
• Do not let children hang on the door.
-
Failure to do so may cause serious personal injury.
• Do not leave the doors of the refrigerator open
while the refrigerator is unattended and do not
let children enter inside the refrigerator.
• Do not allow babies or children go inside the
drawer.
- It can cause death from suffocation by
entrapment or personal injury.
• Do not sit on the Freezer door.
- The door may be broken and cause a personal
injury.
WARNING
CAUTION
WARNING
DA99-03403F(0.0).indd Sec2:3DA99-03403F(0.0).indd Sec2:3 2012.5.2 9:24:52 AM2012.5.2 9:24:52 AM
