To obtain the best possible results from your cassette player, you must clean
it regularly (heads, roller and drive capstan).
Open the deck by pressing the ST/EJ ( ) button.
Use a cotton bud and a special cassette cleaning agent to clean the:
◊
Heads ( )
◊
Roller ( )
◊
Drive capstan ( )
To guarantee hours of enjoyable listening with your cassettes:
◊
Check that the tape in the cassette is always sufficiently taut
◊
Store your cassettes in a clean place, out of direct sunlight, where
they will not be exposed to high temperatures
◊
Avoid using 120-minute cassettes as they are extremely fragile.
RADIO
LW(OPTION)
Frequency range..................................................................150 KHz ~ 290 kHz
SW(OPTION)
Frequency range......................................................................6 MHz ~ 18 MHz
AM(MW)
Frequency range................................................................530 KHz ~ 1605 kHz
FM
Frequency range..................................................................88 MHz ~ 108 MHz
TAPE DECK
Frequency response................................................................125 Hz ~ 6.3 kHz
GENERAL
Output power ........................................................................................0.8 Watts
Dimensions..........................................................264(W) x 145(H) x 135(D) mm
MAINTAINING THE SOUND QUALITY
SPECIFICATIONS
Use of controls, adjustments or performance of
procedures other than those specified herein may
result in hazardous radiation exposure.
SAFETY WARNINGS
CAUTION:
TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE REAR COVER,
NO USER SERVICEABLE PARTS INSIDE,
REFER SERVICING TO QUALIFIED SER-
VICE PERSONNEL.
Wiring the Mains Power Supply Plug(UK Only)
IMPORTANT NOTICE
The mains lead on this equipment is supplied with a moulded plug incorporating a fuse. The value of the fuse is indi-
cated on the pin face of the plug and if it requires replacing, a fuse approved to BS1362 of the same rating must be
used.
Never use the plug with the fuse cover omitted. If the cover is detachable and a replacement is required, it must be of
the same colour as the fuse fitted in the plug. Replacement covers are available from your dealer. If the fitted plug is
not suitable for the power points in your house or the cable is not long enough to reach a power point, you should
obtain a suitable safety approved extension lead or consult your dealer for assistance.
However, if there is no alternative to cutting off the plug, remove the fuse and then safely dispose of the plug. Do not
connect the plug to a mains socket as there is a risk of shock hazard from the bared flexible cord.
Never attampt to insert bare wires directly into a mains socket. A plug and fuse must be used at all times.
IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:–
BLUE = NEUTRAL BROWN = LIVE
As these colours may not correspond to the coloured markings identifying the terminals in your plug, proceed as fol-
lows:–
The wire coloured BLUE must be connected to the terminal marked with the letter N or coloured BLUE or BLACK.
The wire coloured BROWN must be connected to the terminal marked with the letter L or coloured BROWN or RED.
WARNING: DO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL WHICH IS MARKED WITH
THE LETTER E OR BY THE EARTH SYMBOL , OR COLOURED GREEN OR
GREEN AND YELLOW.
This symbol alerts you to important
operating and maintenance instructions
accompanying unit.
WARNING: To reduce the risk of fire or electric
shock, do not expose this appliance to
rain or moisture.
CAUTION: To prevent electric shock, match wide
blade of plug to wide slot, fully insert.
This symbol indicates that dangerous
voltage which can cause electric shock
is present insede this unit.
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
CAUTION
1
2
3
MEMO
— 9 —
