629824
7
Verklein
Vergroot
Pagina terug
1/16
Pagina verder
Guided Tour - Front Panel
1: Handle - For easy transport while carrying, or while rack mounting, the PG amplifier features two die-cast handles located con-
veniently on the left and right side of the front panel.
2: POWER switch - Use this to power the PG Series on or off. The internal LED lights whenever the PG Series is powered on.
3: Vent -The PG series amplifiers stay cool thanks to their twin, forced-air cooling tunnels. Cool air is drawn through the front
panel vents, reducing the temperature of the internal components while forcing the heat out the rear vents. The fans will actually
sense the internal temperature and adjust their speed to maintain the optimum cooling conditions.
4 VOLUME controls - These 42-position detented controls allow you to precisely adjust the input level of the signal arriving at
the rear-panel input jacks (see #2 on the following page). At their fully counterclockwise position (labeled “MIN”), the signal is
attenuated by 80 dB (essentially completely off). At their fully clockwise position (labeled “MAX”), the controls are at unity gain
(that is, no attenuation). When +4 dBu of signal arrives at the input jacks and the Channel input level controls are set to their fully
clockwise “MAX” position, the PG Series delivers full power output.
5: POWER LED - The front panel LED indicator will illuminate when the Power switch is set to the “ON position.
6: PROTECT LED - This goes on for approximately five seconds whenever the PG Series is powered on and then turns off (you’ll
hear a click when it does so). The Protection LED will also light when overheating or other severe problems occur (see page 8
in this manual for more information). It is normal for the Protection LED to fade slowly when the amp is powered off. When lit,
no signal is provided to any connected speakers, thus muting them and preventing any “thump” from occurring. For a complete
description of the conditions under which this light goes on, see the section entitled The PG Series Protection Circuitry on page
8 of this manual.
7: CLIP LED - The CLIP segment lights whenever the channel is outputting signal at full strength. For the best signal-to-noise ratio,
the (CLIP) segment should light occasionally during peak levels; if it lights frequently, you may be overloading the PG Series and a
distorted (“clipped”) signal is probably being output. If this occurs and backing off the Input Level control delivers too low an out-
put level for your application, consider using Bridge mode (see the “Bridge and Parallel Modes” section on page 9 in this manual
for more information).
8: SIGNAL LED - The front panel LED indicators continuously monitor the power output level for the corresponding channel. The
SIGNAL LED lights whenever output signal is present
1 2
3
4
7 8 78
5 6 4 1
3
7

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Samson PG3800 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Samson PG3800 in de taal/talen: Engels als bijlage per email.

De handleiding is 2,19 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info