19
BATTERIES SAFETY PRECAUTIONS
To avoid an
Make sure you have inserted the b
Use only with 1,2V 400mAh type or equivalent rechar
Do not dispose of the batteries in a fire. The cell may explode.
Check with local code for possible special disposal instructions.
Do no
released which can cause injury.
To reduce the risk of fire or personal injury, use only the battery listed in the users guide.
Keep batteries out of the reach of children.
Remove batteries if storing over 30 days.
GENERAL PRODUCT CARE
To keep your telephone working and loo
Avoid putting the phone near heating appliances and devices that generate electr
motors or fluorescent lamps).
DO NOT expose to direc
Avoid dropping and other rough treatment t
Clean with a soft cloth.
Never use a strong cleaning agent or abrasive powder because this will damage the finish.
Retain the original packaging in case you need to ship the phone at a later date.
TROUBLESHOOTING
Causes of poor reception:
Aluminium
Foil backing on insulation.
Heating ducts and other metal construction can shield radio signals.
You are too cl
Atmospheric conditions, such as str
Base installed in the basement or lower floor of the house.
Base i
Baby monit
Handset batteries is low.
You
13
Prefix (depending on version)
If a PABX is used in a private network, you can program
This function sets:
The PABX prefix number: this number will be added at the beginning of the number you dialled.
The number to be detected: if the number you dialled starts with the recorded sequence, this
sequence will be automatically deleted.
These two settings are not applied if number you dialled starts wi
"#", "*" or "P".
1. Go to the menu " advanced set " / " auto prefix ".
- Select"detect digit " to define the number giving you access to the outside line.
- Select "prefix " to specify the «digits befor ».
2. Press
.
Flash timing
If you connect your telephone to a private automatic branch exchange or use it in a foreign country,
you may need to modify the flash duration in order to use your telephone co
following functionalities: outgoing 2nd c
Contact your administrator, who will supply the appropriate time period, and proceed to the new
settings.
1. Go to the menu " advanced set " / " recall time ".
2. Select the appropriate time period, press .
Modifying the dialing mode (de
Most telephone systems use the tone dialling mode. You can, however, use the pulse dialling mode:
1. Go to the menu " advanced set " / " dial mode ".
2. Two modes are available: " tone " and " pulse ".
3. Press .
First ring
Activating this function is only usefyour line does not have the CLIP service.
This menu allows you to arran
connected on the same line with another device (a fax, a cord telephone, etc.).
This function is activated as default. It will be automa
(the number of which will be displayed on the handset screen).
1. Go to the menu " advanced set " / " first ring ".
Use the or key to change the state.
2. Press
.
14
ANSWERING MACHINE (MODEL D17V ONLY )
Your telephone features an a
of remote access.
The answering machine function of you
- Basic answering machine: an announcement indicates that you are not available. Your
correspondent cannot
.
- Recording answering machine: an announcement tells your correspondents that they
you a message, which they can record after
D17V model offer pre-recorded announcements in many languages and a remote
access to your answer
Control panel
:
Description
:
Key Functions
Start playback of the messages.
Stop playback of the messages *.
1 time up: go to the next message.
1 time down: go back to the beginning
2 times down: go back to the previous message.
Delete the current message (Short press in playback
Delete all messages already played back (Press and hold outside
playback mode)
Press "+": Increase the b
Press "-": Decrease the base loudspeaker volume.
Enable or disable the answering machine function.
* The playback resumes from the first message.
15
Enabling / disabling the answering machine
From the base
To deactivate your answering machine, press the
key on the base. The indicator light of the
key goes off.
To activate your answering machine, press again
key on the base. The ind
key turns on blue and the announcement that will be used is broadcast.
Each time you power on your base, the answering machine goes to its previous
state (activated or deactivated).
From the handset
1. Go to "answ machine " / answ. ON/OFF" .
2. Select "ON " or "off " using the or key to activate or deactivate your answering machine,
press
.
Modify the answering machine mode
1. Go to "answ machine "/ " answer m " / " answ. &record " (or " answer only ").
2. Select answ. &record" or " answer only " using the or key, press
.
You will hear a confirmation tone.
Modifying the outgoing message (OGM)
Recording a personal outgoing message
1. Go to "ANSw machine "/ " record ogm "/ " answ. & record " (or "answer only ").
2. Select record ogm " using the or , press
.
3. Clear state your announcement close to the base.
4. At the end of your announcement
. A confirmation beep is iss
If you make a mistake while
until you are satisfied with your announcement.
The maximum recording duration for an announcement is 120 seconds .
The recording start and end beeps are not part of your announcement.
The recording of a new announcement will automatically replace the previous
announcement.
Playing outgoing message
1. answ machine "/ "record ogm "/ " answ. &record. " (or "answer only ").
2. play " using the or key, press
.
The announcement that will be used is broadcast.
After broadcasting the announcement, your answering machine will return to standby mode.
If no announcement is recorded, you will hear a beep.
R
I
16
Delete your personal outgoing message
If you have not saved a personal announcement, the answering machine will
automatically use one of the .
1. Go answ machine " / "record ogm" Answ. / &record " (or " answer only ").
2. Select delete " using the or key, press
.
The anonymous announcement corresponding to the current answering machine mode
(simple/recorder) is automatically played
At the end of the playback, the announcement is deleted and you are back to the previous
menu.
Adjusting the volum
Press successively the top or bottom th o n the base until you obtain a satisfactory level.
Playing messages u
If you have received new messages, the in k ic
flashes on the handset screen.
Press the
key to listen t
- If you have new messages, only the latter will be played, from the most recent one to the oldest one.
- If you have no new messages, all the older messages will be played, from the most recent to the
oldest one.
A beep is issued after each message is broadcast and the next message is broadcast automatically.
For the k
Use it only after 2 seconds as from the start of message playback.
When a message is being left by a correspondent, you can open the line (by
pressing the key) to answer at any
Listen again to the current message
Press the bottom of the key du
Listen again to the previous message
Press twice the bottom of the key to hear the previous message again.
Go to the next mess
During playback of the message, press the top of t
key to skip to t
17
Stop the playback of the messages
Press the key to stop the playback of the messages.
When you press the key a second time the pl
message.
Playing messages using the handset
If you have received new messages, the indicator light of the key flashes blu icon
flashes on the handset.
1. Go to "answ machine " / " Play ".
2. Press
.
Deleting messages
Deleting the current message
During the playback of the message, press the
key.
The message in progress is deleted:
- If you have other messages, the next message is broadcast.
- Otherwise, the answering machine returns to standby mode.
Deleting all messages already played back
1. In standby mode, hold down the
key until you hear a beep.
This beep info
- OR -
1. Go to "answ machine "/ " delete all" .
2. Press
.
3. Press
to confirm deletion.
A beep indicates that all messages already played back have been deleted.
ANSWERING MACHINE SETUP (MODEL D17V ONLY )
Number of rings
This parameter enables you to set the nu
machine answers a call. The number of rings can be set between 2
You can also select the "ECONOMY "mode The " ECONOMy" mode automatically determines the number of
rings: If there are no new messages on the answering machine, the number of rings will be 4,
otherwise the number of rings will be 2.
1. Go to "answ machine "/ " settings " / "ring delay ".
2. In the list, select the desired number of rings (between 2 and 7) or key or the
"ECONOMy " mode, Press .
Remote access to answering ma
Your answering m
messages and set up your answering machine from another telephone located outside your
18
Activate/deactivate remote access
1. Go answ machine "/ "settings " / " remote acc. ".
2. Use or to seleactivate" or " deactivate " setting.
3. Press
key to confir
Remote access control
To remotely access your answering machine: Dial your telephone number and wait for the answering
mach
When your outgoing message is played, press # and enter
default).
The code for remote access to the answering machine corresponds in fact to the
PIN Code of your Base. This code is 0000 by default, and it can be modified from
the "ADVANCED SET / CHANGE PIN" menu (refer to the paragraph Base master
page 11 ).
A beep will indicate access to the answering machine. You can carry out the following operations
1: Previous message. 6 : Delete the current message
2 : Listen to your messages / back to the
beginning of the message
8 : Stop the playback of the message
3 : Next message 9 : Switch OFF the answering machi
Memory status
Your answering machine has a capacity of 15 minutes (2 minutes for the OGM and 13 minutes for
the messages) or 59 messages.
When your answering machine reaches its maximum recording capacity, you can no longer receive
new messages.
20
Auto-di
Proble Soluti
No display
x Ar
are properly installed and connected.
x I
switc
x D
No dial tone
x Ch
Is the base power cord connected to a working outlet?
Is the tele
x D
jack. If there is no dial tone in the second phone, the problem might be yo
wiring or local service.
x Is
x M
x Are the batteries pac
The batter
Dial tone is OK,
but cant dial out
x Ma
Handset does
not ring
x Make
x Yo
phones.
See solutions for «NO dial tone».
You experi
static, noise or
fading in and out.
x Is
Move closer to the base.
x Do
x C
x Make
21
ENVIRONMENT
Preservation of the environment is an essential concern of Sagemcom. The desire of Sagemcom is to
operate systems observing the environment and consequently it has decided to integrate environmental
performances in the life cycle of its products, from manufacturing to commiss
Packaging
The presence of the logo
national organisation to improve packaging recovery and recycling infrastructures.
To facilitate recycl
Batteries
If your product contains batteries, they must be disposed of at appropriate collection
points
.
The product
The crossed-out waste bin stuck on the product or its accessories means that the product
belongs t
In this respect, the European regulations ask you to dispose of it selectively:
x At sa
x
At the collection points made available to you locally (drop-off centre, selective
collection, etc.).
In this way you can participate in the re-use and upgrading of Electrical and Electronic Equipment Waste,
which c
22
TERMS AND CONDITIONS FOR UNITED KINGDOM &IRELAND ONL
In order to apply the guarantee, you should contact the Sagemcom Helpdesk or the retailer where you
purchase
Please make sure that you use your equipment only for the purpose for which it
normal usage conditions.
Sagemcom do not accept a
purpose or any consequence that may arise from this usage.
Should any malfunction arise, the Sagemcom Helpdesk or your retailer will advise you how
A) Genera
Sagemcom undertakes to remedy by repair or exchange at its own convenience, free of charge for labour
and replacement parts, any defects in the equipment during the guarantee period of 12 (twelve) months or 3
(three) months for accessories, from the date of original invoice of the Equipment, where those defects are a
result of faulty workmanship.
Unless the custo
which specifically provides for repairs to be carried out at the customer's premises, the rep
carried out on the equipment at the customer premises.
The custom
by the Sa
In the c
purchase (which is not altered, written on or in any way made illegible) showing that the product is sti
guarantee. In the case that no proof of pu
production date as its reference for establishing the guarantee status of
Apart fr
is not se
immaterial damage, either in or out of the frame of the present guarantee.
If any provision of this guarantee sh
rule applicable to consumers pursuant to their national legislation, such invalidit
or affec
This guarantee does not affect the Customer statutory rights.
B) Exclusions From Guarantee
Sagemcom shall have no liability u
x Damage, defects, breakdown or malf
- Failure to properly follow
- An external cause to the equipment (including but not limited to: lightening, fire, shock, vandalism,
inappropriate conditions of electrical network or water damage o
- Modifications
- Unsuitable operati
- Repair or maintenance of th
x Wear and tear from normal daily use of the equi
x Damage due to insufficient or bad packaging of equipment when returned to Sagemcom
x Usage of new versions of softwthout the previous approval of Sagemcom
x Work on any equipment or software modified or added without the prior written consent of Sagemcom
x Malfunctions not resulting from the Equipment or from software installed in user workstations for the
purpose
Communication problems related to an unsuitable environment including:
- Problems related to access and/or connection to the Internet su
network
- Transmission faults (for example poor geographical coverage b
interference or poor line quality)
- Local network
as but not limited to interferences, fault or poor quality
- Modification of the parameters of the cellular or broadcast network carried out after the sale of the
Product
23
x Normal servicing (as defined in the user guide supplied with the equipment) as well as malfunctioning
due to servicing not being carried out. Servicing costs are in any event alw
x Malfunctions resulting from the usage of products
equipment.
C)
Out of Guarantee Repairs
In the cases set forth in B) as well as a
Authorised Sagemcom Repair Centre for a cost estimation prior to work being carried out.
In such cases, the
The foregoing shall apply unless otherwise agreed in writing with the customer and only for the United
Kingdom and Ireland.
www.sagemcomdigital.co.uk
TERMS AND CONDITIONS FOR OTHER COUNTRIES
If, des
the proof of purchase that they gave you on the day of purchase.
Should any malfunctioning arise, the retailer will advise you what to do.
For the warranty to apply, you should ensure that the product was used in accordance with the instructions
for use and the purpose for use, and that you have
date of purchase, the name of the retailer, the r
No coverage shall be given under
x The required documents have been
x The ma
x Interventions on the
x The product has b
x The product has b
accidental damage, improper care as well as all Acts of God.
This present warranty does not affect the consumer rights that you may have under the laws in effect in your
country.
Important:
Should you return the product to the after-sales department, please ensure that you return as well all the
elements
253484036A
Dépliant LU D17TV__EN.fm Pag
