9
PARTS OF THE TOOL
1 - Identification plate
2 - ON-OFF switch
3 - Switch locking button
4 - Tool body
5 - Rear handle
6 - Gearbox
7 - Side-handle housing
8 - Additinal handle
9 - Chuck
10 - Mobile ring (NL 13 - NL 16)
11 - Fixed ring (NL 13 - NL 16)
12 - Motor ventilation slotts
STARTING UP
Before starting-up the tool, ensure that:
- the packaging is complete and does not show signs of having been
damaged during storage or transport;
-the tool is complete; check that the number and type of
components comply with that reported in this instruction booklet;
- the power supply and socket outlet can support the load reported in
the table and that indicated on the tool identification plate
reproduced and explained on page 11.
ASSEMBLING THE TOOL
ASSEMBLING THE SIDE HANDLE
Screw the handle (8) into the threaded hole on the gearbox. The
handle can be positioned on the right or left of the tool.
FITTING DRILL BITS
1. Keep the chuck still using the fixed ring and unscrew the mobile
ring until the jaws are sufficiently open to hold the drill bit.
2. Lock the drill bit by rotating the upper part of the chuck in a
clockwise direction.
3. Check that the bit does not rotate off-centre.
MIXERS ASSEMBLY
1. Hold the mixer chuck with the stready ring and release the swivel-
ling ring to expand the jaws;
2. lock the mixer paddle turning clocwise the chuck swivelling ring;
3. check the mixer paddle balancing.
BEFORE STARTING THE TOOL
Ensure that:
- the power supply conforms with the characteristics of the tool;
- the power supply cable and plug are in perfect condition;
- the ON/OFF switch works properly though with the power supply di-
sconnected;
- all the parts of the tool have been assembled in the proper manner
and that there are no signs of damage;
- the ventilation slots are not obstructed (7);
- the dust bag is enipty and not torn.
STARTING AND STOPPING
- Starting:
push the switch level (2) so that it enters the housing in the
rear handle. To lock the switch in the on position, press the lock but-
ton (3) at the same time.
- Stopping:
release the switch. If locked in poition, keep pressing un-
til the look is released.
TEST RUN
Start the machine and check the drill-bit or mixing-paddle alignment.
Otherwise, switch-off the tool immediately and eliminate the cause.
