on the battery side corresponds to the groove on
the battery housing.
4. OVERLOAD PROTECT
When the power is too low or load is overload,
the drill will stop to rotation. The drill still can
rotation when the power is high or load is small.
Insert the battery pack
5. KEYLESS CHUCK OPERATION
The keyless chuck on your drill/driver allows for
easy installation, removal and lock of bits and
drills. The chuck has two rotating grips. To open
or close the jaws of the chuck, hold grip and with
you free hand rotate part “A” forward and rever-
se. Do not use unnecessary force to tighten the
chuck.
5.1. AUTOMATIC-LOCK DRIVE
The Automatic-lock drive on your tool allows for
easy installation, removal and lock of screw bits
and sockets. There is a Lock-sleeve outside the
drive. To install or removal the screw bits or soc-
ket, push the lock-sleeve though the arrow direc-
tion, then use you free hand to install or removal
the bits or socket. Do not use unnecessary force
to tighten the chuck.
6. VARIABLE SPEED CONTROL
Simply apply light pressure to the trigger to start
the drill on the slow speed. Increasing the pres-
sure on the switch will increase the speed of the
drill.
7. CHANGING DIRECTION OF THE ROTA-
TION
Set the direction of the rotation lever to F (for-
ward) and R (reverse). Noted that the direction of
the rotation lever is locked when the on-off
switch is activated. The reversing or anti-clockwi-
se operation enables application for tasks such
as loosening or removing screws.
Noted
: Do not change the direction of rotation
when the drill running.
8. TORQUE ADJUSTMENTS
This feature allows setting of the torque or tighte-
ning power of your drill/driver and depending on
the application, various levels of driving power
are required. When driving larger screw diame-
ters a higher torque power is required to drive
the screw until it’s properly seated. When the
selected torque is reached the chuck will stop
rotating.
Noted
: Always stat on the lowest setting. The
Drill symbol gives the highest torque setting and
is used when drilling and for driving larger
screws.
9. MAINTENANCE
Either the drill or the charger require any special
maintenance. Keep both the drill and the charger
in a dry place where they will not be expose for
frost of direct sunlight.
10. WARNING
To assure safety and reliability, all repairs should
be performed by an Authorised Service Center
8
