15
EN
MAINTENANCE
It is important that you switch off the appliance with button (A) and unplug before any
maintenance operation.
You can clean the appliance with a slightly damp cloth.
IMPORTANT: Never use abrasive products which could harm your appliance’s appearance.
FILTERS
This appliance has three types of filters:
1- Pre-filter 2 - Activated charcoal filter 3- HEPA filter
For optimum performance of the appliance, only use filters provided by ROWENTA. (see
PURCHASING FILTERS section).
To preserve the quality of the filters, they are protected in packaging that must be removed before
use.
The filters must be installed in the order indicated below (see Figure 5 for the operations).
Cleaning cycle and filter replacement:
Each service lifetime is based on a daily use of 8 hours at speed 1.
The recommended frequency for cleaning and filter replacement can vary depending on the
operating environment.
The pre-filter can be re-used (remove the dust using a hoover or wash using water).
WARNING: Never use a pre-filter that is still wet.
The appliance's efficiency can be reduced if the pre-filter is not cleaned regularly.
The activated charcoal filter and the HEPA filter cannot be cleaned and re-used. Never wash in water.
Resetting the filters:
The reset light flashes when a filter needs replacing.
The reset light indicates which filter needs replacing.
- Odour light: activated charcoal filter
- HEPA light: HEPA filter
Once the filter has been replaced, hold down the reset button for 2 seconds (button D).
Forced reset:
If you have replaced a filter before its end of life, force the reset of the filter replacement cycle.
Hold the reset button for 2 seconds.
Press the reset button to select the filter you have changed.
After selecting the filter to reset, hold the reset button for 2 seconds. The electronic
meter is then reset.
If no button is activated for 10 seconds in forced reset mode, the reset mode is cancelled.
