33
Step 14:
If the appliance is not needed any
more, switch it off and pull the
mains plug.
Step 15:
Clean the appliance and the
accessories.
Power save mode:
After 10 min. without operation,
the appliance switches to power
save mode, without heating of the
thermoblock. The pilot lamp blinks
slowly (every 2 sec.).
By actuating the switch ON/OFF, the
appliance can be activated again.
After a short heating-up phase, the
appliance is ready for use.
Frothing milk
Ě )RUKDYLQJSHUIHFWUHVXOWVZHUHFRPPHQG
ĊXVLQJUHIULJHUDWHGPLONRQO\
ĊXVLQJDVWDLQOHVVVWHHOMXJ
Ě 'LSWKHKRWZDWHUVWHDPQR]]OHLQWKHPLONDQGVWDUWIURWKLQJLQWKHXSSHUWKLUGRIWKHPLON+ROGWKHMXJDOLWWOHVODQW
and slightly move it up and down. The nozzle must remain under the milk surface as otherwise the milk froth will be
too large-pored. (After a few trials and with a little practice, you will quickly fi nd the correct method).
Ě Attention: Make sure that the holes in the nozzle are always clean and not clogged.
Ě Attention: For moving the nozzle, only touch it at the upper plastic part.
Ě Attention:$IWHUIURWKLQJWKHV\VWHPPXVWEHFRROHGPDQXDOO\VHHVWHSVĘ
Nähere Informationen
hierzu fi nden Sie unter
ē5HLQLJXQJXQG3ûHJHĐ
Ě &KHFNWKHZDWHUWDQN
regularly, refi ll water if
necessary.
Ě &KHFNWKHGULSSDQ
regularly, empty it if
necessary.
Step 2:
Position the portafi lter without fi lter
insert at the marking of the brew
head and lock it by turning it to the
right as far as it will go.
Step 3:
Place a vessel below the outlet of
the hot water/steam nozzle.
Warning: Casing, brew head,
portafi lter, fi lter inserts and hot
water/steam nozzle are getting hot
GXULQJXVH
Step 1:
Prepare the appliance.