6
Getting the Camera Ready
Installing Memory SD/MMC Card and Battery
1 Open the battery/memory card cover and slide the
memory SD/MMC card (optional) and two new AA
Ni-MH batteries or one CRV3 Lithium battery into
compartments.
2 Close cover securely until it clicks shut.
3 Battery level is shown in 3 stages, Full Battery, Low
Battery, and Insufficient Battery. Only Low Battery and
Insufficient Battery are indicated on LCD screen.
NOTE
Be sure the correct orientations of the batteries and SD/MMC card..
Remove batteries if camera is not used.
Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type recommended by the manufacturer. Dispose of used batteries properly..
Switching the Camera ON/OFF
1 To switch ON, turn Mode Dial from OFF to the desired
shooting mode
( ). Use “Full Auto” ( )
mode if it’s your first time to use. Green power LED
lights up when power is ON.
2 To switch OFF, simply return the Mode Dial back to
“Off” position and the Green Power LED lights OFF.
Note: The camera will power off automatically if camera inactivity for 8 minutes from
the LCD time out.
Viewing the Total/Remaining Shots Available
1 Turn ON the camera.
2 The total/remaining shots number of internal memory
is displayed. If a memory SD/MMC card is installed,
the LCD will display the total/remaining shots number
of the SD/MMC card.
Note: The displayed remaining shots number will vary
according to the set of image resolution and quality.
Battery Low Alert
When the battery becomes low, a low battery icon will display
and the red Power LED will blink. Replace batteries when
power is low.
Batteries
SD Card Slot