OD/DS 0 TouchWah
L out
R out
Pan L
Pan R
L in
R in
Touch
Wah
Overdrive/
Distortion
Amp
Simulator
2-Band
EQ
Parameter Value Explanation
Drive Switch OFF, ON Turns overdrive/distortion on/o
Drive Type OVERDRIVE,
DISTORTION Type of distortion
Drive 0–127 Degree of distortion
Also changes the volume.
Tone 0–127 Sound quality of the Overdrive eect
Amp Switch OFF, ON Turns the Amp Simulator on/o.
Amp Type SMALL, BUILT-IN,
2-STACK, 3-STACK
Type of guitar amp
SMALL: Small amp
BUILT-IN: Single-unit type amp
2-STACK: Large double stack amp
3-STACK: Large triple stack amp
TWah Switch OFF, ON Wah on/o
TWah Mode LPF, BPF
Filter type
LPF: The wah eect will be applied over a wide frequency
range.
BPF: The wah eect will be applied over a narrow frequency
range.
TWah Polarity DOWN, UP
Direction in which the lter will move
UP: The lter will change toward a higher frequency.
DOWN: The lter will change toward a lower frequency.
TWah Sens 0–127 Sensitivity with which the lter is modied
TWah Manual 0–127 Center frequency at which the wah eect is applied
TWah Peak 0–127
Width of the frequency region at which the wah eect
is applied
Increasing this value will make the frequency region
narrower.
TWah Balance D100: 0W–D0: 100W
Adjusts the volume balance between the sound that is
sent through the wah (W) and the sound that is not sent
through the wah (D).
Low Gain -15–+15 [dB] Amount of boost/cut for the low-frequency range
High Gain -15–+15 [dB] Amount of boost/cut for the high-frequency range
Level 0–127 Output Level