To select Inactive Hours:
4.3.2 Mowing Extent
4.3.2.1 Mowing Hours
There are cases, when some specific areas in a lawn are not mowed properly or some patches of uncut grass are visible.
This may occur in two cases:
) The actual area of the lawn is bigger than the one configured in the Area settings. In this case go to the Lawn
Options > Zone Edit > Area menu to adjust the area settings.
) The lawn’s shape is complex (shape, narrow passage, slopes and obstacles).
If the area settings are correct, but the mowing results are still not satisfactory, the ‘Mowing Hours’ option allows adjusting
the duration of mowing cycle allocated for your area setting (by percentage).
To change the ‘Mowing Hours’ follow these steps:
After Setting the Mowing Hours one of the following messages will be displayed:
Robomow will not operate on the hours you have set. Inactive hours are the same for all days of the week.
If too many hours have been deactivated relative to your lawn size, Check Inactive Time message will be displayed.
Mowing Hours Updated: When the selected value was accepted.
Mowing Hours Limit: If the selected Mowing Hours value is higher than the maximum allowed one for the lawn
area. Press
to set or to re-select.
Scroll to select Inactive Time from the Lawn
Options Menu. Press
.
Scroll to select Hours. Press
.
Scroll to select between 1
st
or 2
nd
time slot and
press .
You can deactivate up to 2 time slots.
Scroll to toggle the inactive window On/Off.
Press
.
Set the start and end times for this time slot.
Scroll to select OK box. Press .
Scroll to select Mowing Extent from the
Lawn Options menu. Press
.
Press
to select Mowing Hours.
Scroll to select All Zones / By Zone. Press
.
If By Zone is selected scroll to select Zone.
Press
Scroll to increase or decrease the Mowing
Hours percentage. The default is 0% and can
be changed from -50% to +50%.
