How Robomow Works for You
Perform a One-Time Setup before operating Robomow for the first time.
[Detailed instructions are in the following chapters]
• First, you will install a wire around the entire lawn and around protected areas within
the lawn area. This wire is the Perimeter Wire; it sets the boundaries for Robomow.
Small pegs are supplied with Robomow. You use them to fasten the Perimeter Wire to
the ground, below grass level. The Perimeter Wire will gradually disappear under the
growth of new grass and will become invisible quite soon.
Then, you will place a Base Station along the Perimeter Wire and install a Power Box.
They perform two basic functions:
o Generate a very low voltage signal along the Perimeter Wire.
o Charge Robomow’s batteries.
• After having completed the installation of the Perimeter Wire, the Base Station, and the
Power Box, and performing the One-Time Setup, Robomow will do all the mowing for
you the entire season !
• Robomow leaves its Base Station on the scheduled mowing time. Robomow mows the lawn and then drives itself back to the
Base Station to be charged and ready for its next scheduled mowing.
• In order to prevent damage to the lawn at the Base Station area and in order to improve lawn coverage, Robomow will drive
back from the Base Station at a random distance (between 90cm to 120cm) and will randomly select an angle of departure
between 40 to 90 degrees.
• As soon as Robomow departs for mowing, the Base Station automatically triggers a special signal. This signal creates a virtual
wall, visible only to Robomow. This signal keeps Robomow within the lawn boundaries, and prevents it from entering areas it
was intended to skip.
Robomow detects the signal
and changes direction as it
reaches the wire
Perimeter Wire as a
virtual wall, visible only
to Robomow
Tree surrounded by a groove, ditch or flower beds requires a wire around it .
Base Station and Power Box:
- Generates signal along the wire.
- Charges Robomow’s battery.
Large trees: Robomow is allowed to bump
into them. At this size, the objects do not
require a Perimeter Wire around them.
Peg
Perimeter Wire
Base Station Power Box
