512472
17
Verklein
Vergroot
Pagina terug
1/60
Pagina verder
17
The setup of the entering to the narrow pass leads to the Base Station should include
triangles to reduce the chance that Robomow will enter towards the station while mowing
the inner area (scanning); to perform the triangle setup refer to Figure 1.7.
The distance between the wires lead to the Base Station and back to the lawn is 26cm (10
inches).
The Base Station should be placed on the right wire of the narrow pass (when standing
inside the lawn).
Important: as the two wires are very close and affect the wire sensors readings, the Base
Station should not be aligned with the central lines marked on the Base Station; it should
be placed with a shift of 10-20cm (4-8 inches) to the right.
It is reccomneded to placed the Base Station at least 25cm (10 inches) before the end of
the external pass to allow the mower smooth entrance to the Base Station.
1.4 Perimeter Wire Setup
Now, knowing the location of the Base Station and the planning of the wire layout, you can begin to
setup the Perimeter Wire in the Base zone.
1.4.1 Starting Point
Place the Base Station according to your plan
with the fence towards the inner side of the
lawn, as shown in Figure 1.11 or 1.13;
Puncture the plastic covering of the perimeter
wire and pull the wire ends with the plot
connector out of the plastic covering; The
connector should be connected to the wire in
the polarity show in Figure 1.12;
The plastic covering is designed as a dispenser
for the wire; so do not remove the wire spool
from the covering;
Peg the beginning of the wire to the ground
where the Base Station will be located; be sure
to leave 30cm (12 inches) to close the loop at
the end of the setup (Figure 1.13);
Start laying the wire to the counterclockwise direction when standing inside the lawn, as show in
Figure 1.13.
Begin pulling the perimeter wire out of the plastic covering and lay it loosely as you walk along
the area of the lawn to the direction shown in Figure 1.13;
Figure 1.12 – Pull out the wire from the
plastic covering – do not remove the
covering; it is designed as a dispenser.
Figure 1.11 –
External Base Station Setup
26cm /10“
Triangle as done in
narrow pass type B
(refer to Figure 1.7)
R
e
c
o
m
m
e
n
d
e
d
(
u
p
t
o
3
m
/
1
0
f
t
)
Base Station is placed with a right
shift of 10-20cm (4-8“)
(not aligned with the wire)
Recommended to continue
the wire for at least 25cm
(10”) after the Base Station
26cm /10“
Triangle as done in
narrow pass type B
(refer to Figure 1.7)
R
e
c
o
m
m
e
n
d
e
d
(
u
p
t
o
3
m
/
1
0
f
t
)
Base Station is placed with a right
shift of 10-20cm (4-8“)
(not aligned with the wire)
Recommended to continue
the wire for at least 25cm
(10”) after the Base Station
17

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Robomow-RM510

Zoeken resetten

  • Ik krijg constant de melding 'Bumper ingedrukt', de robot blijft dan rondjes draaien rond wijn as en begint niet te maaien. Wat kan ik hieraan doen? De melding verdwijnt en de robot rijdt soms een halve minuut rond wanneer ik tegen de achterbump aanduw tijdens het opstarten van het maaiproces. Gesteld op 10-3-2024 om 11:53

    Reageer op deze vraag Misbruik melden
  • Hoe repareer ik de perimeterdraad eerst koperdraad aan elkaar en dan in de draadconnectoers? Gesteld op 25-6-2019 om 17:37

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Robomow RM510 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Robomow RM510 in de taal/talen: Engels als bijlage per email.

De handleiding is 3,2 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Robomow RM510

Robomow RM510 Gebruiksaanwijzing - Nederlands - 60 pagina's

Robomow RM510 Gebruiksaanwijzing - Deutsch - 60 pagina's

Robomow RM510 Gebruiksaanwijzing - Français - 61 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info