37
Adjustment of the planer tables (fig. 5,6)
To ensure the planer outfeed table is set at exactly the same height as the planer knives, a simple device can
be used as seen in fig 6.
Take a piece of square wood and put 10 marks at exactly 1 mm interval, and put one planer knive at its
heighest point, and put your scale with the 0 ontop of the planer knife.
Now turn the planer arbor 1 turn by hand (use the brake release switch) and if the scale is moved for not
more than 2 marks, this means the knives are well set.
Loosen bolt 1 and use the lever 2 for changing the height of the outfeed planer table.
Fig.5 Fig.6
Planer fence (fig. 7)
The planer fence can be adjusted according to the width of the worpiece by loosening the handle (1) and
sliding the fence to the front or back.
After unlocking the handle (2) and pushing the lever (3) the fence can be set at any angle between 90° and
45°.
The 90° positive stop can be adjusted underneath the fence support, the 45° positive stop can be adjusted
ontop of the fence support.
Angles can be read at the scale.
Make sure all clamping handles are well tightened before starting to work.
Fig.7
2
1
3
1
2
