520094
13
Verklein
Vergroot
Pagina terug
1/105
Pagina verder
RF module
Stick mode / Reset
FX-40
13
5.10 INSTALLING AND REMOVING THE RF MODULE
Always switch off the transmitter before inserting the RF module.
Position the RF module squar
ely before pushing it into place.
Take care that no pins are bent when you insert the connector.
To remove the RF module simply pull it out, keeping it straight and
“square”.
5.11 COMBINATION TOOL / STYLUS
The combination tool supplied is designed for various purpo-
ses:
As stylus for the touch-scr
een LCD panel, with the rubber
cap fitted.
Without the rubber cap: as special spanner for undoing and
tightening the crown-nuts used to retain the switches in the
switch panels.
The 1.5 mm A/F allen key is used to alter the stick centring
spring force, and to adjust the stick unit ratchet or brake.
The 2.5 mm A/F allen key is used for the switch panel
screws and for adjusting the aerial base.
5.12 WINDOWS RESET
If Windows CE™ should hang or crash, you need to carry out
a system reset. Remove the transmitter battery for a few
seconds, then replace it; the system then restarts. A system
reset and restart is r
equired if any of the following should
occur:
The screen remains black, and the transmitter fails to start.
The screen display does not move; the screen is said to
have “frozen”.
The transmitter cannot be switched off.
The screen responds unusually slowly.
Regardless of any Windows messages which may appear,
the transmitter continues to operate normally. Please land
the model and switch of
f the receiving system before carry-
ing out a reset.
Next time you switch the transmitter on, it will carry out a reset
automatically.
CHARGING THE TRANSMITTER BATTERY
Connect the 230 V mains charger to a mains socket: “1”.
Connect the plug attached to the mains char
ger to the 12 V Lithium
charger: “2”.
Connect the charge lead attached to the 12 V charger to the trans-
mitter; the monitor lamp “4” now lights up.
The charge monitor LED “5” glows red to indicate that charging is
taking place; the charge current is around 2 Amps.
If the battery is fully discharged, the charge period is around 3.5
hours.
The colour of the charge monitor LED “5” changes to green when
the charge process is complete.
A replacement LT4F5000 battery is available under No. 4554.
To protect the environment, defective or exhausted batteries must
never be discar
ded in the household waste; they should always be
taken to the appr
opriate collection point or battery recycling centre, as
defunct batteries can be recycled effectively.
Do not submerge the battery in water or any other liquid.
Do not heat or incinerate the battery, or place it in a microwave
oven.
Do not short-circuit the pack or charge it with reversed polarity.
Do not subject the battery to physical pressure; do not deform or
throw it.
Do not solder directly to the battery.
Do not modify or open the battery.
Do not charge the battery to a voltage higher than 4.2 Volts per cell,
or discharge it to a voltage lower than 2.5 Volts per cell.
Li-Po batteries may only be charged using a charger designed
expressly for this purpose. Never connect the battery directly to a
mains PSU.
Never charge or discharge the battery in direct sunshine, or close
to a heater or fire.
Do not use the battery in any location which is subject to severe
static discharges.
Any of these errors may cause the battery to be damaged, explo-
de or catch fire.
Keep the battery well out of the reach of children.
If electrolyte should escape, keep it well away from fire. The sub-
stance is highly inflammable and may burst into flames.
Avoid the fluid electrolyte contacting your eyes. If this should occur,
rinse the affected part immediately with plenty of clean water befo-
re seeking medical attention.
If the fluid electrolyte should contact your clothes or any other
object, immediately wash it off using plenty of water.
1
2
4
3
5
13

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Robbe Futaba FX-40 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Robbe Futaba FX-40 in de taal/talen: Engels als bijlage per email.

De handleiding is 3,91 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Robbe Futaba FX-40

Robbe Futaba FX-40 Gebruiksaanwijzing - Deutsch - 105 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info