10
Assembly of the bottom plate
Assembly of the belt tensioner
1x bottom plate
1x
belt tensioner basic body
3x ball bearing 624ZZ (diameter inside/outside (8.8/13 mm)
4x washer (diameter inside/outside 4.3/8.8 mm)
1x
cylinder head screw M4x30
1x cylinder head screw M5x70
1x nut M4
Insert belt tensioner basic body into the intended breakout of
the bottom plate. The cross-bore of the belt tensioner basic
body and the bore in the bottom plate must align.
Push
washers onto the M4x30 screw alternatingly with the ball
bearings.
Screw the screw equipped in this manner, as shown in the fig-
ure, into the belt tensioner basic body and tighten it well.
Counter
the screw with the nut at the belt tensioner basic body
(in the figure on the bottom of the bottom plate).
The screw head of the belt tensioner (on the right in the figure)
is supported against the housing side part to be installed later
so that the belt tensioner function is only present after assem
-
bly of the side part
Assembly
of the Spacers
4x spacers
1x bottom plate
4x cylinder head screw M5x16
Turn
the bottom plate and attach the spacers to the top of the
bottom plate with the screws as shown.