5
• Never reach into the 3D printer in operation. The mechanically moved parts within the printer pose a high risk of inju-
ry!
• The print head and the heating plate grow very hot in operation. Never touch these parts during or just after operation.
Let them cool down suciently first (approx. 60 minutes).
• The
mains unit corresponds to the applicable CE provisions. Compliance with the applicable CE provisions for the
finished construction kit, whoever, is subject to the constructor of the construction kit and also essentially depends on
precise work during assembly.
• All persons who operate this product, mount, install, assemble it, put it into operation or service it must be trained and
qualified accordingly and must observe these operating instructions.
• Disconnect the device from the mains before maintenance work or modifications (unplug the mains plug) and let it
cool down.
• In operation, there will be noise and, depending on the filament material used, smells. Observe this when selecting
the site of setup and the filament material. Ensure sucient ventilation or install an extraction system. Do not inhale
arising vapours. When using any other than the recommended filament material, poisonous vapours or gases may
develop.
• The 3D printer is not suitable for persons with physical, sensor or metal limitations or for inexperienced or uninformed
persons.
• This product is not a toy and not suitable for children. Children cannot judge the dangers involved when handling
electrical devices.
• This
device is a safety class 1 product. The only permissible voltage source is a properly grounded mains socket
(100-240 V/50/60 Hz) of the public mains.
• The devices must not be exposed to any extreme temperatures, strong vibrations, high moisture, such as rain or steam
or strong mechanical strain.
• Never place containers containing liquids, e.g. glasses, vases, etc. on the device or in its vicinity and do not pour any
liquids out over the device. Liquids may get into the housing and impair electrical safety. This also poses great danger
of fire or potentially fatal electric shock!
If this is the case, first power down the respective mains socket on all poles (e.g. switch o circuit breaker and FI
switch) and then pull the mains cable from the socket. Disconnect all lines from the device. Do not operate any part of
the product anymore afterwards, but take it to a specialist workshop.
• Never
place any sources of open fire, such as lit candles, on or right next to the device.
• Do not touch the mains cable if it is damaged. First power down the respective mains socket on all poles (e.g. switch
o circuit breaker and FI switch) and then pull the mains cable from the socket. Never operate the product with a
damaged mains line.
• When setting up the product, make sure that the mains cable is not pinched or damaged by sharp edges.
• Never
touch the mains line or the mains plug with wet or damp hands. There is a risk of potentially fatal electric
shock!
• The mechanical parts of the product are produced highly precisely. Never apply any mechanical force here. The
3D printer may be rendered useless by this.
• Never operate the device unattended.
• Only
operate the device in moderate climates, never in tropical climates.
• Do not leave any packaging material unattended. It may become a dangerous toy for children.
• If you are not sure of the correct connection or if there are any questions that are not covered by the operating instruc
-
tions, do not hesitate to contact our technical support or another specialist.
• Also observe the additional safety information in the individual chapters of these instructions.
