490473
1
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
VARTA Consumer Batteries GmbH & Co. KGaA
Alfred-Krupp-Str. 9
73479 Ellwangen
Germany
www.remington-europe.com
©





0RGHO1R+&+&+&
+&
8.+&
9HUVLRQ
3DUW1R
7
6%,
+&+&+&
+$,5&/,33(5
&RUG&RUGOHVV
REMINGTON
®
is a Registered Trade Mark of Spectrum Brands, Inc., or one of its subsidiaries
44-0650-902000
REMINGTON
®
SERVICE HOTLINES
1. 2.
5.4.
3.
United Kingdom
+44 0800 212 438 (free call)
Rayovac Europe Ltd,
Watermans House, Kingsbury Crescent,
The Causeway, Staines, Middlesex,
TW18 3BA, UNITED KINGDOM
www.remington.co.uk
SPRACHE
1
1
Thank you for choosing Remington. Our products are designed to meet the high-
est standard of quality, functionality and design. We hope you enjoy using your
new Remington
®
product.
Please read the instructions for use carefully and keep in a safe place for future
reference.
CAUTION
Use this appliance only for its intended use as described in this manual. Do not
use attachments not recommended by Remington.
Do not use this product if it is not working correctly, if it has been dropped or
damaged, or dropped into water.
DESCRIPTION
1. On/Off switch
2. Blade set
3. 8 attachment guide combs
4. Charge indicator light
5. Charging adaptor
ENGLISH
SPRACHE
2
GETTING STARTED
CHARGING YOUR HAIRCLIPPER
Before using your hair clipper for the fi rst time, charge for 14-16 hours.
Ensure the product is switched off.
Connect the charging adaptor to the product and then to the mains. The charging indica-
tor will light up.
Your clipper cannot be overcharged. However, if the product is not going to be used for an
extended period time (2-3 months), unplug it from the mains and store. Fully recharge your
hairclipper when you would like to use it again.
To preserve the life of your batteries, let them run out every six months then recharge for
14-16 hours.
CORDED USE
Connect the charging adaptor to the product and then to the mains.
CAUTION: Extended mains only use will result in the reduction of the battery life.
HOW TO USE
Before starting the cut
Inspect the clipper making sure that it is free from hair and dirt.
Seat the person so that their head is approximately at your eye level.
Before cutting, always comb the hair so it is tangle free and dry.
To attach a comb
Hold the comb with its teeth upward.
Slide it onto and along the clipper blade until the front of the comb fi rmly sits against the
clipper blade.
To remove the comb
Holding the clipper with the blades facing away from you, fi rmly push the comb upward
and away from the blades.
ENGLISH
2
3
Each comb attachment is marked accordingly on its outside middle surface surface
(3mm, 7mm, 9mm, 12mm, 18mm, 25mm, left and right ear guide).
Replacement combs available. Model: SP254.
INSTRUCTIONS FOR HAIR CUTTING
Note: For even cutting, allow the comb attachment/blade to cut its way through the hair.
Do not force it through quickly. If you are cutting for the fi rst time, start with the
maximum comb attachment
STEP 1 – Nape of the neck – DIAGRAM 1
Use 3 mm or 7 mm guide comb.
Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of the
head at the base of the neck.
Slowly lift the clipper, working upwards and outwards through the hair, trimming just a
little at a time.
STEP 2 – Back of the head – DIAGRAM 2
With the 12 mm or 18 mm guide comb attached, cut the hair at the back of the head.
STEP 3 – Side of the head – DIAGRAM 3
With the 3 mm or 7 mm guide comb attached, trim sideburns. Then change to the longer
9mm guide comb and continue to cut the top of the head.
STEP 4 – Top of the head – DIAGRAM 4
With the 18 mm or 25 mm guide comb attached, cut hair on top of the head against the
direction in which the hair normally grows.
For longer hair on top, use without a guide comb. Lift the hair on top of the head with a
small hand comb. Cut over the hand comb with the hair lifted or hold the hair between
the fi ngers to lift it and cut it to the desired length.
Always work from the back of the head.
STEP 5 – The fi nishing touches – DIAGRAM 5
Use the clipper without an attachment comb for close trimming around the base and sides
of the neck. Use the ear comb guides to get a clean line around each ear. For the required
ear comb guide, angle the clipper and lightly stroke around each ear to the back of the
neck.
To produce a clean straight line at the sideburns, reverse the hair clipper. Place the
reversed clipper at right angles to the head, tips of the blades lightly touching the skin and
then work downwards.
3
SPRACHE
4
4
SHORT TAPERED STYLES – “FLAT TOPS” & SHORT CUTS
Starting with the longest guide comb attached (25mm), cut from the back of the neck
to the crown. Hold the guide comb fl at against the head and slowly move the clipper
through the hair, as shown. (DIAGRAM 1)
Use the same procedure from the lower side to the upper side of the head, as illustrated.
Then cut the hair against the direction in which it grows and level with the sides.
(DIAGRAM 3)
To give a “ at top” look, the hair on top of the head must be cut over the top of a fl at
comb.
Use a closer guide comb to taper the hair down to the neckline as desired.
CARE FOR YOUR HAIRCLIPPER
Your clipper is fi tted with high quality titanium blades. To ensure long lasting performance
of your clipper, clean the blades and unit regularly. Always keep the protective cap on the
trimmer blade and lubricate the clipper lightly before and after cleaning.
AFTER EACH USE
Note: This product is only washable if purchased in the United Kingdom and has a three-
pin charging adaptor. Due to European legislation we are unable to offer this feature in
Western and Eastern European countries.
Ensure the clipper is switched off and disconnected from the mains.
Brush or rinse the accumulated hair from the blades. Do not submerge the clipper in
water.
Place one or two drops of oil on the blades. Turn the clipper on to distribute the oil even-
ly, wipe off any excess oil. Excess oil will cause damage to your product.
To clean the unit, wipe with a damp cloth and dry immediately.
Note: Ensure that the clipper is turned off when cleaning or applying oil.
EVERY SIX MONTHS
At regular intervals the Blade Set should be removed and cleaned.
Remove the 2 screws retaining the fi xed blade with a screwdriver. Do not remove blade
set.
Brush out hairs from between the blades with soft cleaning brush. Do not remove the
lubricating grease from the blades. It is not necessary to remove the small moving blade
from the unit.
ENGLISH
5
5
If the moving blade has been removed this can be re- tted by slotting the long grooved
edge of the blade onto the two white plastic guide ridges and then seating the blade over
the plastic actuator bar. The fi xed blade is fi tted with the raised profi le pointing outwards
and fi xed with the 2 screws.
Before fully tightening the 2 screws, adjust the taper lever to the lower position and
align the blades so that their cutting edges are parallel to one another. Tighten the 2
screws. Note that if the blades are not correctly aligned then cutting ef ciency will be
impaired.
Place a few drops of cutter or sewing machine oil onto the blades. Wipe off excess oil.
CLEANING CAUTIONS
Cleaning should only be done with a soft brush, such as the brush supplied with the
product.
Only use the light-grade oil supplied or sewing machine oil on the blades.
Do not use harsh or corrosive cleaners on the units or their blades. Do not submerge in
water as damage will occur.
Do not wrap the cord of the charging adaptor around the appliance.
IMPORTANT SAFETY INSTRUCTIONS
WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR
INJURY TO PERSONS:
An appliance should never be left unattended when plugged into a power outlet.
Keep the power plug and cord away from heated surfaces.
Make sure the power plug and cord do not get wet.
Do not unplug the product with wet hands.
Do not use the product with a damaged cord. A replacement can be obtained via our
Remington
®
Service Centre.
Charge, use and store the product at a temperature between 15°C and 35°C.
Always unplug from the mains when cleaning.
Only use the parts supplied with the appliance.
Keep this product out of reach of children. The use of this appliance by persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge can
give cause to hazards. Persons responsible for their safety should give explicit instructions
or supervise the use of the appliance.
The product contains a Nickel-Metal Hydride cell unit.
Do not dispose the trimmer in
household waste at the end of its useful life. Disposal can take place at our service centres
or appropriate collection sites.
CAUTION: Do not put in fire or mutilate your battery packs as they may burst or release
toxic materials.
For further information on recycling see www.remington-europe.com
1

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Remington HC650 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Remington HC650 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,28 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info