470000
16
Verklein
Vergroot
Pagina terug
1/36
Pagina verder
Prevent the cable chang where it enters and exits the mast.
Minimize electrical interference by:
Not running the cable near other electrical equipment.
Not running the cable alongside power cables or antenna
cables for other equipment.
Power requirement
The HD Digital Radome Antenna must be supplied with power by
either a 12 V dc or a 24 V dc supply. Do NOT connect to a 32 V
system.
If you are replacing an existing Radome scanner with an HD Digital
Radome Antenna, you must also replace any existing cable with the
appropriate digital cable, as described in section 2.7 Cables.
If you connect to the power supply via an isolator switch, the
minimum switch rating is:
For a 12 V system, 20 A.
For a 24 V system, 15 A.
Caution: Do NOT connect to positive
ground system
Do NOT connect this product to a
positively-grounded system.
Power Supply Protection
The power supply must be protected by a suitable thermal circuit
breaker or fuse, tted close to the power source. The protection
requirements are the same for both 18” and 24” HD Digital Radome
Antennae, and are as follows:
In a 12 V system, protect the power supply with either a 10 A
thermal breaker, or a 15 A fuse.
In a 24 V system, protect the power supply with either a 5 A
thermal breaker, or an 8 A fuse.
Power cable lengths
The total permitted lengths of power conductor run (i.e. power cable
plus cable extension) from the power source to the HD Digital
Radome Antenna are :
for 12 V systems, 20 m (65 ft)
for 24 V systems, 35 m (115 ft)
If you want to connect to a 12 V power system but a total power
conductor run of more than 20 m is necessary, the use of a suitable
voltage converter is recommended, to convert the 12 V supply
voltage to 24 V, and thus enable you to extend the run up to 35 m.
We recommend using a converter with a minimum 200 W output
capacity.
Grounding
These grounding requirements are applicable for Raymarine
equipment supplied with a separate drain wire or screen.
• The product power cable drain conductor (screen) must be
connected to a common ground point.
It is recommended that the common ground point is a bonded
ground, i.e. with the ground point connected to battery negative,
and situated as close as possible to the battery negative terminal.
If a bonded ground system is not possible, a non-bonded RF
ground may be used.
16
HD Digital Radome Users Guide
16

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Raymarine HD Digital Radome Antenna bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Raymarine HD Digital Radome Antenna in de taal/talen: Engels als bijlage per email.

De handleiding is 2,3 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info